Johnson Controls PAN-PWRSP-0 96 VA 120/24 VAC Power Assembly

Auto-Tuned Control Loops

Reduce commissioning time, eliminate change-of

season re-commissioning, and reduce wear and tear on

mechanical devices.

The M4-XPM series I/O expansion modules can serve

in one of two capacities depending on where they are

installed in the Metasys system. When installed on

the Sensor/Actuator (SA) Bus of a Metasys equipment

controller, an XPM expands the input and output

interfaces that can be used with that equipment

controller. When installed on the Field Controller (FC) Bus

of a Metasys network engine, an XPM can be used as I/O

point multiplexors to support monitoring and control from

a Metasys network engine. The point multiplexor can also

be useful for sharing points between other equipment

controllers on the FC Bus using peer-to-peer connectivity.

Models to support both BACnet MS/TP and N2. with

auto-detection of the communications protocols

Controller auto-detects the BACnet MS/TP or N2 protocol

that is connected to it, which enables the same controller

to support multiple communication protocols without

the need to purchase a special model per protocol, and

without extra manual setup.

BACnet automatic discovery

Supports easy controller integration into a Metasys BAS.

Wireless ZFR and ZFR Pro support

Provides a wireless alternative to hard-wired MS/TP

networking, offering application flexibility and mobility

with minimal disruption to building occupants, and also

simplifies and speeds up replacements.

Integral real-time clock

An integral real-time clock, which enables the controllers

to monitor and control schedules, calendars, and trends,

and operate for extended periods of time as stand-alone

controllers when offline from the Metasys system network.

BACnet Testing Laboratories (BTL) listed and certified

Ensures openness and interoperability with other BTL

listed devices. BTL is a third-party agency, which validates

that BAS vendor products meet the BACnet industry

standard protocol.

Pluggable screw terminal blocks

Pluggable input/output wiring terminal blocks provide

electrical installers and field technicians the ability to

quickly and easily install and service a controller without

the need to disconnect and reconnect the input/output

wiring.

Johnson Controls MS-NAESCBL-0 Diagnostic cable and non-metallic reset probe

Johnson Controls MS-FEC1611-1 B-ASC 10-Point Field Equipment Controller

Johnson Controls MS-BAT1010-0 Replacement data protection battery for secure NAE-S

Johnson Controls PAN-PWRSP-0 96 VA 120/24 VAC Power Assembly

Johnson Controls DRP-24V48W1AZ (rev04) CliQ DIN Rail 24 VDCPowerSupply with connecting cable

Johnson Controls MS-DIS1710-0 Local Controller Display

Johnson Controls DIS1710 INSTALLATION INSTRUCTIONS MANUAL

Johnson Controls METASYS FEC2621 FIELD EQUIPMENT CONTROLLER MS-FEC2621-0

Johnson Controls FIELD EQUIPMENT CONTROLLER MS-FEC2611-0ET 24VAC REV

Johnson Controls Metasys NAE MS-NAE5510-3 Ver 10.0 Rev K Controller 

Johnson Controls MS-NAE5510-ER2 Panel consisting of the Secure Network Automation Engine

Johnson Controls MS-NAE551S-2 Secure NAE-S Network Automation Engine

Johnson Controls MS-NAE551S-702 Replacement secure NAE-S