Streamline power transfer with DEIF's AGC 150 ATS controller

Streamline power transfer with DEIF's AGC 150 ATS controller

Ideal for emergency power applications with any power source, the AGC 150 ATS

is a robust, flexible, and user-friendly ATS controller that can operate up to three breakers.

The AGC 150 ATS is a dedicated automatic transfer switch (ATS) controller capable

of handling any type of power source. Its flexible setup options let you use it in a

wide range of emergency power solutions by controlling up to three breakers.

The IP65 certified front-mounted controller is easy to install, set up, and use.

Any power source in Source-Source mode

In addition to Generator-Mains mode (operating the ATS to switch between a mains

incomer and a genset), the AGC 150 ATS can operate in Source-Source mode,

accepting any kind of power source (for example two mains incomers, or a combination

of mains or a genset with a battery energy storage system or a renewable power source).

The controller can send start and stop signals to both sources.

Many operating options

The AGC 150 ATS uses automatic mains failure (AMF) logic and control signals defined

by the controller’s input/output settings to operate the ATS. For example, it can monitor

a mains source for voltage, frequency, and voltage anomalies, switching to the secondary

source in case of issues (after sending a start signal and checking that the voltage from

the secondary source is within the defined limits, if needed).

Flexible blackout prevention options

Designed for flexibility and efficient blackout prevention, the AGC 150 ATS includes an

Overlap feature that prevents blackouts during source switching by keeping the breakers

of both sources closed for a user-defined period and enabling short-time paralleling.

You can prioritise sources using parameters or digital inputs, offline or online, and you

can prioritise one of the connected sources, let the controller prioritise a source randomly,

or prioritise both in a three-breaker setup.

Two or three breakers supported

The AGC 150 ATS can control two or three breakers, allowing you to open and close a bus

tie breaker between the two power sources if needed. The controller can therefore be

configured for use in virtually any ATS application, anywhere in the world, including

the use of two sources simultaneously.

Easy setup and operation

You can easily configure the AGC 150 ATS for your application by adjusting its built-in

parameters or by using the M-Logic feature in DEIF’s free USW-3 utility software.

The sunlight readable LCD provides easy setup and quick access to important information.

On-screen text can be displayed in 8 languages, and the illuminated buttons smoothly

guide the operator and make the controller very easy and intuitive to operate.