Emerson IC758RSWC12PCX512 Replacement Back for 12" RXi -Panel PCEmerson Bezel- 16GB RAM, 512GB SSD

Integrated power distribution. Controller and I/O interface

power distribution is integrated into the carriers to reduce and

simplify power and grounding. I/O Carriers have an integrated

shield ground bar to isolate and drain field noise away from

system power. They also provide an integrated redundant 24V

DC bussed field power distribution to reduce installation wiring

and provide fused, isolated power to each I/O interface, using

Power Buss Plugs. Alternatively, the I/O carriers can be ordered

with Power Terminal Plugs to bring dedicated power to each

card, which can be either 24V DC or 120/230V AC. Power Buss

Plugs and Power Terminal Plugs can be mixed on one

I/O Carrier.

A single Power Terminal Plug will come with any 120V AC DI

or 120/230V AC DO card.

The field network is wired in a ring configuration from Port A around a loop to Port B of the

network master. Beginning at Port A, the network is wired to Port A of the first actuator and

then from Port B of the first actuator to Port A of the second actuator and so on until the

network returns from Port B of the last actuator to Port B of the network master. Networks

may have parallel wired (bus wired) actuators between series wired actuators. Always wire

parallel actuators to Port A and remove termination and bias. Do not connect more than 15

actuators in parallel between any two series connected actuators. Networks are polarized with

(+) and (-) symbols on all drawings. Proper operation requires that polarity be observed at all

connections. Connect the field networks to the Port A and B connectors on the NIM in the

network master as shown in Figure 9. The networks must be connected to Port A and Port B

of the valve actuators as shown in the wiring diagram of the XTE3000/ICON3000 IOM. Others

320B and RTS, please refer to their IOM for network wiring diagram. Controlinc 320B Quick

Start manual. Controlinc supports many different network topologies. This manual supports

only a single ring E>Net network topology that allows a combination of parallel (bus) and series

E>Net connections on the same network.

Foxboro FPS400-24 P0922YU Standard 200 Series Power Supply

Foxboro RH101AA Industrial Control Module

Foxboro H90C9AA0117S Compact programmable logic controller

Foxboro H92A049E0700 Workstation for Windows Operating Systems

Foxboro RH931RQ Cable Terminal

EMERSON VE3007 KJ2005X1-BA1 12P4375X012 Industrial Controller Module

Emerson A6140 9199-00058 Digital Valve Controller

EMERSON A6824R 9199-00098-13 Industrial Control Module

EMERSON 5X00502G01 Ethernet Communication Interface Module

EMERSON 5X00500G01 Ethernet Communication Interface Module

EMERSON KJ3002X1-BF1 12P1732X042 Analog Input Card RTD

EMERSON 1C31234G01 "Digital Input Electronics Module"

EMERSON 9199-00002 A6120 Monitoring Module

EMERSON A6110 9199-00001 Dual-Channel Shaft Relative Vibration Monitoring Module

EMERSON A6410 9199-00005 Shell Expansion Monitoring Module

EMERSON A6824 9199-00090 Analog Input Module