ENOTEC COMTEC® 6000 The fast and reliable in-situ O2 & COe analyzer

The COMTEC 6000 is an in-situ gas analyzer for measuring oxygen and

COe (the sum of unburned molecules such as carbon monoxide,

methane, or hydrogen) in flue and process gases.

This enables redundant, highly accurate, real-time measurement of both

gases, allowing for efficient combustion optimization. This is achieved by

combining the MXP sensor for COe analysis with the MLT sensor

technology for calculating the oxygen content.

Both sensors are located within the process, as the probe is installed

directly in the flue gas duct.

Precise flue gas analysis can thus be performed continuously, resulting

in the very high response speed of this flue gas analyzer to changes in

gas composition compared to extractive analyzers. In the design of this

analyzer, particular attention was paid to low maintenance, minimal

calibration effort, and unrestricted user-friendliness.

Furthermore, high investment and maintenance costs, especially

compared to extractive analyzers, can be avoided.

Technical data

Process gas temperature max. 500 °C

to 1400 °C (with cooling protection tube)

Measuring principle O₂ Zircon oxide

Immersion depth/material 440 mm / 900 mm / 1820 mm, 500 mm /

1000 mm with cooling protection pipe, stainless steel (SS316TI)

Measuring principle COe MXP (mixed potential)

Ambient temperature Probe: -40°C to +80°C | Electronics: -20°C to

+55°C

O₂ - Measuring ranges Two freely selectable measuring ranges:

0-2 vol.% to 0-25 vol.% (others on request)

COe - Measuring ranges 0 to 5000 ppm

Housing Probe: IP65 | Electronics: IP66