GE IS200AEPAH1AHD PLC Module Brand

The Multilin C30 controller system is a substation hardened device designed to perform substation

control logic that can also expand the I/O capability of protection devices and replace existing SOE

recorders. The C30 provides fast and deterministic execution of programmable logic with I/O capabilities

far above an average protection relay.

Graphical programming tools, supported by a library of logic operators, make the C30 simple to use

and configure. Using high-speed peer-to-peer communications for inter-device messaging, the C30 can

also accept signals and commands from other protection and control devices at a fraction of the cost

of hard-wiring these signals.

Reliable, Interoperable and Future Proof

The MU360 complies with the main standards for digital

substation IEC 61869-9. IEC 61850 edition 2.1 and IEC 61869

13. which guarantees its interoperability and compliance to the

requirements for being the physical to digital interface of modern

digital substations. Furthermore, measurements of each CT/VT

set may be broadcasted in protection and power quality profiles,

allowing multiple Protection, Automation and Control applications

to consume the data without needing extra footprint for acquisition.

Test Modes

IEC 61850 edition 2.1 provides standard mechanisms for testing

purposes, reducing commissioning complexity and allowing new bay

installations without affecting substation operation.

With the test modes in MU360 users can independently configure

mode and behavior of each logical devices allowing then to operate

as: On, Test, Blocked, Test/Blocked and Off.

A Safer and Cybersecure Substation

Transmitting the instrument transformers´ measurements digitally

through optical fibers eliminates the risk of inadvertent mishandling

of the current and voltage circuits and makes the relay room a safer

work environment, eliminating hazards and reducing the risk of

personnel injury.

To ensure MU360 have all this connectivity in a cybersecure way, it

has been designed according to IEC 62443 and have all capabilities

described by SL2 of this standard, including RBAC, secure boot and

signed firmware.

Communications

The D485 Modbus to DeviceNet Converter acts as a gateway between a Modbus RTU

network and a DeviceNet network. Integration of Modbus devices into DeviceNet

networks is enabled without loss of functionality, control, and reliability, both when

retrofitting to existing equipment as well as when setting up new installations.

The D485 Modbus to DeviceNet Converter is an external DIN-rail mounted device

which provides DeviceNet network connectivity via a serial RS232/RS422/RS485 interface.

The D485 is programmed using the P485/D485 configuration cable and the

EnerVista P485/D485 Setup Software.