Emerson IC758COWA15PC64 15" RXi - Panel PC Emerson Bezel-4GB RAM, 64GB SSD

Each I/O interface carrier is supplied with connectors for direct mating together.

A single I/O subsystem supports a total of eight 8-width I/O interface carriers for a maximum of 64 local I/O interface cards.

Cable extenders are used to connect carriers that cannot be installed next to each other,

allowing the carriers to be arranged in standard equipment cabinets.

The extender has two 22-pin D-type connectors and supports a dual cable fault-tolerant configuration.

Ports A and B are connected in parallel so that either port can be used.

The new Dual Carrier Extender also supports the redundant secure bus coaxial connectors used by DeltaV SIS.

The total length of the I/O bus is 6.5 metres (21.3 feet).

The VerticalPlus carrier can also be used for Zone 2 remote I/O devices to provide installation flexibility.

The standard modular components typically consist of the following:

• Electronics module

• Personality module

• Base Unit (containing the field terminations)

The relay output modular components consist of the following:

• Electronics module

• Base Unit (containing the field terminations)

Two H1 interfaces can be mounted in adjacent slots using the 2-wide redundant terminal block. 

The DeltaV controller recognizes the presence of redundancy and presents both cards as a single pair within the system. 

There is no additional user configuration required to set up the redundant H1 hosts. 

Segment Power is provided using third party Ff power supplies that also provide segment physical layer diagnostics. 

The H1 interface segment wires connect to these power conditions while a separate segment trunk wire connects to the field devices

Recommended Products P/N：