ABB FPX86-9345--B 3BHL000986P0006 Analog Output Board

REM615 is a dedicated motor protection and control relay designed for the protection, control, 

measurement and supervision of induction motors in manufacturing and process industry. 

REM615 is a member of ABB’s Relion® product family and part of its 615 protection and control product series. 

The 615 series relays are characterized by their compactness and withdrawable-unit design. 

Re-engineered from the ground up, the 615 series has been designed to unleash the full potential of the 

IEC 61850 standard for communication and interoperability between substation automation devices.

Once the standard configuration relay has been given the application-specific settings, it can directly be put into service.

Disturbance recorder function

The three conductor currents, the current in the directly earthed conductor,

binary signals, and the voltages, can be recorded in each BU. 

Recording can be started, for example, by a protection function or an input signal. 

The disturbance recorder data are stored in the REB 500. 

They can be read out directly on the BU or at the central unit in COMTRADE format and stored on the PC. 

An evaluation program (eg, WINEVE) is used for further processing.

REF542plus Multifunction Protection and Switchbay Control Unit integrates all the secondary functions in a single unit. 

This multifunctional unit also features a selfmonitoring function. 

All functions are designed as freely configurable software modules. 

Therefore, a wide range of operation requirements in MV stations can be met without any problems. 

The versatility of the software makes it possible to use the REF542plus on every 

switchboard independent on the specific application required.

Overcurrent-time protection

This is a back-up protection function which is calculated locally in the BU and used to provide simple,

autonomous feeder protection in each BU.

Event recording

All events are stored with a resolution of 1 ms in the central unit and in the BUs.

System, protection and test events can be generated.

Protection events refer to the protected busbar and include the changes in the disconnector and breaker positions,

trips, etc. Test events are recorded during testing with the test signal generator.

System events describe the diagnostic and fault messages of the NBP system as a whole.

VMIVME-2540-300  24-Channel Intelligent Counter/Controller

VMIVME-4514A-000 16-Channel Scanning Analog I/O Board

VMIACC-5595-208   Specification 

VMIVME-3122 High-Performance 16-bit Analog-to-Digital Converter

VMIVME-3123 Specifications 

VMIVME-7700 Ultra Low Voltage Intel® Celeron® VMEbus

VMIVME-4116 8-channel 16-bit digital-to-analog converter board

VMIVME-7805 VMEBus SBC Motherboard

VMIVME-2128 Output Module

VMIVME-3100 analog-to-digital conversion module

VMIVME-2170A Isolated Digital Output Module

V7865 processor VME single board computer

V7865-ACC-603-RC VME Transition Module for V7865