A-B 1783-MS28RAC Stratix 5410 Ethernet Managed Switches

SERCOS Interface Modules

The SERCOS interface modules use a single, digital fiber-optic link, which

eliminates as many as 18 digital wires per axis. Detailed drive-status

information can be sent from drive to controller and from controller to drive.

The SERCOS interface modules can connect to these servo drives:

• 2093 Kinetix 2000 multi-axis servo drive

• 2094 Kinetix 6000 multi-axis servo drive

• 2099 Kinetix 7000 high-power servo drive

• 2098 Ultra3000 SERCOS servo drive

General

The power converter modules DCS800-S have the protection class IP00 and are to be mounted in a cubicle or finger protected area. 

There are different sizes (D1. D2. D3. D4. D5. D6. D7), graduated in terms of current and voltage ranges.

All units are equipped with the DCS800 Control Panel. 

It can be snapped into place on the power converter module or installed in the switchgear cubicle door by means of amounting kit. 

Accessories such as external fuses, line reactors etc. are also available, to complete the drive system. 

All converter modules up to 525 V and 1000 A (D1...D4) are equipped with field exciters.

The power section of the converters is available as single  (2-Q) bridge or double (4-Q) bridge. 4-Q drives are required for regenerative breaking. 

4-Q drives can be built by:

–Double (4-Q) armature bridge or –Single (2-Q) armature bridge plus a double (4-Q) field converter bridge

The bridge type has an influence on the maximum output voltage of the converter. See table below.

Restrictions

• Volts per Hertz operation requires the use of the Custom User Defined Controller Communication Format.

If another Controller Communication Format is selected (e.g. Velocity Control, 

Position Control or User Defined Control) and the drive is configured for Volts per Hertz operation, 

the Drive Module will not connect to the controller.

• This module sometimes experiences PMI Comm faults during power cycles.

For example, when the Drive Module and PMI processor are power-cycled the drive module initializes its interface

with the PMI processor. During the transition from initialization to synchronized communication,

the Drive Module sometimes experiences communication faults and warnings. 

AEG DEA202-B Modicon

AEG Modicon Cutter Electric PLC A500 Digital Output Output Card DAP001 DAP

AEG AS-C921-100 INTERFACE MODULE COMM. PROCESSOR REV A ASC921100

AEG Modicon 170 bdi 356 00 Interbus TIO Module 042 703 807

Modicon TSX P5730 Processor TSXP5730

AEG Modicon DAU208 Analog Output Module

1PCS  AEG AS-BDEO-216 Modicon ASBDEO216 Discrete Input

Schneider AEG Modicon AS-B865-001 Register Input Module ASB865001

AEG MODICON AS-B827-000 ASB827000 INPUT MODULE

AEG Modicon Isolated Output Module AS-B810-008 115VAC

AEG MODICON AS-B806-032 OUTPUT MODULE P/N: AS-8713-000 OUTPUT MODULE 120 VAC

AEG Modicon AS-B351-001 PLC Input Module Schneider Electric Gould