A-B 1783-BMSO6SL Stratix 5700 Ethernet Managed Switches

The power converter modules DCS800-S have the protection class IP00 and are to be mounted in a cubicle or finger protected area. 

There are different sizes (D1. D2. D3. D4. D5. D6. D7), graduated in terms of current and voltage ranges.

All units are equipped with the DCS800 Control Panel. 

It can be snapped into place on the power converter module or installed in the switchgear cubicle door by means of amounting kit. 

Accessories such as external fuses, line reactors etc. are also available, to complete the drive system. 

All converter modules up to 525 V and 1000 A (D1...D4) are equipped with field exciters.

The power section of the converters is available as single  (2-Q) bridge or double (4-Q) bridge. 4-Q drives are required for regenerative breaking. 

4-Q drives can be built by:

–Double (4-Q) armature bridge or –Single (2-Q) armature bridge plus a double (4-Q) field converter bridge

The bridge type has an influence on the maximum output voltage of the converter. See table below.

ATTENTION: 

The installation of the drive must be planned such that all cutting, drilling, tapping and welding can be accomplished with the drive removed from the enclosure. 

The drive is of the open type construction and any metal debris must be kept from falling into the drive. 

Metal debris or other foreign matter may become lodged in the drive circuitry resulting in component damage. ! 

An incorrectly applied or installed drive can result in component damage or a reduction in product life. 

Wiring or application errors, such as, undersizing the motor, incorrect or inadequate AC supply, 

or excessive ambient temperatures may result in malfunction of the system. ! 

Only qualified personnel familiar with DC drives and associated machinery should plan or implement the installation, 

start-up and subsequent maintenance of the system.

Failure to comply may result in personal injury and/or equipment damage.

These faults and warnings can be cleared with a clear faults command. 

You may have to perform a reset after power-up, or perform multiple resets.

Local DH+ Messaging Devices use local DH+ messaging to communicate between devices on the same physical link.

AEG Modicon Modnet 1/IS Master BKF 102.6065-042.703 580

AEG Modicon SPS A250 Interbus Bus Baugruppe Interface BKF101 BKF 101

AEG MODICON AM-S985-800 MODBUS PLUS NETWORK ADAPTER

AEG Modicon SFC 6504 CMOS-RAM PCB | P/N: 6051-042.23968 3

C924 - Aeg Modicon - C916-100 / Plc Cpu Module Card

AEG Modicon Micro 110 CPU 311 00 043506698 01.11

AEG MODICON MICRO 110 CPU 311 00 043503055 1.1

Asb849016 - Aeg Modicon - As-B849-016 / 48vac/dc Input

AEG/Modicon S985-000 S985 Modbus+ Network Adapter Module S985000

Gould Modicon 484 (AS-C484-266) Programmable Controller w/ AEG Interface

Modicon/AEG AM-S908-000 Remote I/O Processor Rev B2 AMS908000 PLC Module

Modicon 100-427 Memory Card Circuit Board AEG

SCHNEIDER AUTOMATION TSX QUANTUM-140 ESI 062 10 - COM/ASCII MODULE 2XRS232

ASB875001 - AEG MODICON - AS-B875-001 / Analog Input Module S800