Emerson IC758ROWB12PCX128 Replacement Back for 12" RXi-PanelPcEmerson Bezel-8GB RAM, 128G8 SSD

Mounting of Rack Mount Enclosure

The enclosure is designed for standard EIA 19 in. DIN rail rack mounting. Dimensions of the

enclosure are shown in Figure 7. The enclosure conforms to EIA RS-310. IEC 297-1. and DIN 41

494. Part 1 standards. The rack in which the enclosure(s) are mounted must allow a minimum

of 20 in. / 508 mm depth, allowing space for cable connections. If the system includes backup

LCD keypad terminals, some planning is required to allow for proper height above the floor to

view the display and operate the keypad properly.

The DeltaV™ S-series hardware takes the proven DeltaV

hardware to a new level of robustness and ease of use.

Assembly is faster and power distribution is easier, with fewer

connections using the integrated field power distribution and

increased capacity of I/O bus power.

The field network is wired in a ring configuration from Port A around a loop to Port B of the

network master. Beginning at Port A, the network is wired to Port A of the first actuator and

then from Port B of the first actuator to Port A of the second actuator and so on until the

network returns from Port B of the last actuator to Port B of the network master. Networks

may have parallel wired (bus wired) actuators between series wired actuators. Always wire

parallel actuators to Port A and remove termination and bias. Do not connect more than 15

actuators in parallel between any two series connected actuators. Networks are polarized with

(+) and (-) symbols on all drawings. Proper operation requires that polarity be observed at all

connections. Connect the field networks to the Port A and B connectors on the NIM in the

network master as shown in Figure 9. The networks must be connected to Port A and Port B

of the valve actuators as shown in the wiring diagram of the XTE3000/ICON3000 IOM. Others

320B and RTS, please refer to their IOM for network wiring diagram. Controlinc 320B Quick

Start manual. Controlinc supports many different network topologies. This manual supports

only a single ring E>Net network topology that allows a combination of parallel (bus) and series

E>Net connections on the same network.

Foxboro FPS400-24 P0922YU Standard 200 Series Power Supply

Foxboro RH101AA Industrial Control Module

Foxboro H90C9AA0117S Compact programmable logic controller

Foxboro H92A049E0700 Workstation for Windows Operating Systems

Foxboro RH931RQ Cable Terminal

Foxboro E69F-BI2-S Current-to-Pneumatic  Signal Converter

Foxboro P0926JM 8 Position Modular Baseplate

Foxboro E69F-T-I2-JRS Current-to-Pneumatic  Signal Converter

Foxboro B4H254-8F8T X440G2-12T8FX-GE4 Industrial Control Module

FOXBORO A4H254-8F8T P0973JP Managed Ethernet Switch