A-B 1783-WAPAK9 Stratix 5100 Wireless Access Point/Workgroup Bridge

Restrictions

• Volts per Hertz operation requires the use of the Custom User Defined Controller Communication Format.

If another Controller Communication Format is selected (e.g. Velocity Control, 

Position Control or User Defined Control) and the drive is configured for Volts per Hertz operation, 

the Drive Module will not connect to the controller.

• This module sometimes experiences PMI Comm faults during power cycles.

For example, when the Drive Module and PMI processor are power-cycled the drive module initializes its interface

with the PMI processor. During the transition from initialization to synchronized communication,

the Drive Module sometimes experiences communication faults and warnings. 

The 1756-DHRIO and 1756-DHRIOXT modules use the Controller Slot

configuration parameter to send the message to the local controller. 

You must use RSLinx software to configure the controller slot. 

Some messages, called PCCC commands, are not sent to the controller slot. 

In this case, the 1756-DHRIO and 1756-DHRIOXT modules generate a response to the message. 

For a complete list of these messages, see Appendix B. 

Local DH+ messaging does not require a populated routing table. 

Local DH+ messaging does require a default (that is a properly emptied) or

an applied (that is a properly populated and saved) routing table, 

and a default or applied controller slot for each channel configured for DH+. 

A modern control system is more than its name implies. It delivers the fast system performance, 

high capacity and optimized productivity that you need from a control system today.

SST WOODHEAD 5136-SD-ISA REV: 2.4.1 INTERFACE CARD

WOODHEAD SST DHP-PCI V1.2.0 SD-PCI-U DATA HIGHWAY PLUS INTERFACE CARD

Molex SST-PB3-VME-2 Brad Communication Board SSTPB3VME2E

SST Woodhead SST-ESR2-CLX-RLL Ethernet Modbus/Serial Modbus Communication

Woodhead PB3-PCIe 2 SST-PB3-PCIE 1 V1.1.0 Communication card

MOLEX SST-DN4-PCIE-H / SSTDN4PCIEH 

SST 5136-PFB-PCI Profibus Communications Adapter Module

AMAT 0190-34511 REV. 08 SST woodhead DNet bus scanner DNPCPCI3U1-NC- 3V V1.3.4

WOODHEAD SST-DN3-PCU-1 DEVICENET INTERFACE CARD

SST / WOODHEAD 5136-PFB-VME PROFIBUS INTERFACE CARD 5136PFBVME NIB

WOODHEAD SST-DN3-PCU-2( E) PCI DEVICENET INTERFACE CARD DN3-PCU-2(E) V1.2.8

Brad Communications / Fanuc / Woodhead. SST-PFB3-VME-1 -E.

SST/Woodhead 5136-DNP-104 Interface Module DeviceNet I/O Driver