Woodward V90RD-3030-FBE 9907-1902 ACTUATOR w/REMOTE SERVO

For redundant operation, the control can use any combination of power supplies.

The power supplies can only be installed into slots PS1 (power supply #1) and PS2 (power supply #2).

If redundant power supplies are not needed, blanking plates must be installed in the slots not being used.

Branch circuit fuses, circuit breakers, and wiring must meet appropriate codes and authorities having

jurisdiction for the specific country (CE, UL, etc.). See Table 4-3 for maximum recommended fuse or

breaker ratings. Do not connect more than one main power supply to any one fuse or circuit breaker. Use

only the wire sizes specified in Table 4-3. which meet local code requirements. Time delay fuses or circuit

breakers must be used to prevent nuisance trips.

Power requirements depend on the number and type of modules supplied for each system. For a system 

with a single I/O chassis, size the input power source according to the rating of the MicroNet power 

supply to which the source is connected. Do not size the supply mains for the sum of the MicroNet power 

supply ratings when redundant supplies are used. MicroNet supplies are redundant when installed in the 

same chassis. Redundant supplies share the load between them equally, but each must provide for full 

load in the event that one of the units is disabled. Table 4-4 gives the maximum overload protection for 

supply mains connected to any single or redundant pair of MicroNet main power supplies. It is not 

recommended that both MicroNet main power supplies of a redundant pair be connected to a single 

source, since failure of that source would disable the system. 

Multiple chassis systems using MicroNet power supplies may have power supplies of the same model, 

but in different chassis, connected to the same source. In this case, each branch to a chassis must have 

its own overcurrent protection sized according to Table 4-4, and the power source must be sized for the 

sum of the branches.

Woodward Discrete Input - 16 Channel 8200-1104

Woodward Discrete Output - 16 Channel 8200-1105

Woodward Termination Resistor Kit 8923-1889

Woodward Dataforth I/O Thermocouple - K-Type 1784-1028

Woodward Dataforth I/O RTD - 100 Ohm 1784-655

Woodward Dataforth I/O 4-20 mA Input 1784-659

Woodward Table A. NetCon Analog Cables 12 feet, Black 5416-349

Woodward Table A. NetCon Analog Cables 14 feet, Black 5416-350

Woodward Table A. NetCon Analog Cables 16 feet, Black 5416-351

Woodward Dataforth I/O 0-5 VDC Input 1784-657

Woodward Network Switches Ethernet - 8 Port, RJ45 Connectors 1711-1350

Woodward Table A. NetCon Analog Cables 6 feet, Black 5416-346

Woodward Table A. NetCon Analog Cables 8 feet, Black 5416-347

Woodward Table A. NetCon Analog Cables 10 feet, Black 5416-348