HIMA 52100 Time Delay Module



Product Description

The safety-related F3 AIO 8/4 01 remote I/O is a compact system located in a metal

enclosure with 8 analog inputs and 4 analog outputs.

The remote I/O is available in three model variants for SILworX and three model variants

for ELOP II Factory, see Chapter 3.3. All variants are described in this manual.

The remote I/O serves as extension of the I/O level of HIMax and HIMatrix controllers, and

is connected to them via safeethernet. The remote I/O itself is not able to run a user

program.

The HIMatrix remote I/Os are not multi-master capable.

The remote I/O is suitable for mounting in Ex-zone 2. see Chapter 4.1.3.

The device has been certified by the TÜV for safety-related applications up to SIL 3 (IEC

61508. IEC 61511 and IEC 62061), Cat. 4 (EN 954-1) and PL e (EN ISO 13849-1). Further

safety standards, application standards and test standards are specified in the certificate

available on the HIMA website.

Safety Function

The remote I/O is equipped with safety-related analog inputs. The input values on the

inputs are safely transmitted to the connected controller via safeethernet. The outputs are

safely assigned their values by the connected controller via safeethernet.

Safety-Related Analog Inputs

The remote I/O is equipped with 8 analog inputs with transmitter supplies for the unipolar

measurement of voltages, referenced to L-.

The remote I/O is intended to measure the voltage on the inputs. To measure the current

on the inputs, connect a resistor of up to 500 Ω in parallel to each input.

Only shielded cables with a length of a maximum of 300 m must be connected to the

analog inputs. Each analog input must be connected to a twisted pair of wires. The

shielding must be connected to the remote I/O and the sensor housing and earthed of one

end to the remote I/O side to form a Faraday cage.

If an open-circuit occurs during voltage measurement (the line is not monitored), any input

signals are processed on the high-resistance inputs. The value resulting from this

fluctuating input voltage is not reliable; with voltage inputs, the channels must be terminated

with a 10 kΩ resistor. The internal resistance of the source must be taken into account.

For a current measurement with the shunt connected in parallel, the 10 kΩ resistor is not

required.

The analog inputs are designed to retain the metrological accuracy for 10 years. A

recalibration must be carried out every 10 years.

ALSTOM 029.076164 PC BOARD MODULE

Alstom Safety Hard Hat Application Engineering

ALSTOM MOTPRO MCHNM PROTECTION RELAY MCHNM01H1AB0500A

GEC ALSTOM RFC15001006A POWER SUPPLY MODULE

GEC ALSTOM KBCH13001H15MEL Transformer Differential Protection Relay KBCH

ALSTOM CEGELEC ALSPA 20X4264/60C , 20X4264A1L

Alstom Low Burden Tripping Relay MVAJ13L1GB0771A

ALSTOM MVAJ105RA0802A Protection Relay

Micom Alstom P143 Feeder Management Relay P143311A1A0040A

CONVERTEAM 029.211-759 / 029211759

CONVERTEAM 8321-6002 / 83216002

CONVERTEAM 029.223-006 / 029223006

CONVERTEAM 029.226681 / 029226681 

Alstom 70B002 Pcb Circuit Board Rev B