EATON MTL5521 ALARM DRIVER

Eaton’s Cutler-Hammer FP-4000 Feeder Protection Relay provides

complete 3-phase and ground overcurrent and voltage protection

plus metering. It may be used as primary protection on feeders, mains

and tie circuit breaker applications, and as backup protection for trans

formers, high voltage lines and differential protection. The relay is most

commonly used on medium voltage switchgear applications.

The FP-4000 takes full advantage of its microprocessor technology,

providing the user new freedoms and a wealth of data-gathering

features. The relay performs self-checking of all major hardware and

firmware protection elements to ensure their operation in the event of

a system or component electrical failure or fault. Protection functions

are well suited for main and distribution feeder circuit applications.

Programmable logic control functions make the FP-4000 relay ideally

suited for main-tie-main and main 1/main 2 transfer schemes.

The zone interlocking feature can be utilized for bus protection instead

of an expensive and complicated bus differential (87B) scheme.

The FP-4000 works directly with the Cutler-Hammer Digitrip 3000

and Digitrip MV relays. New breaker failure logic provides faster

remote backup clearing times for stuck breaker operation.

The FP-4000 provides trip and close circuit monitoring and alarming

features. It continually monitors the complete trip and close circuits

for continuity and readiness to trip. Open and close pushbuttons are

conveniently located on the front of the relay for local breaker operation.

Loss-of-vacuum monitoring is activated when the breaker is open.

Residual current is monitored and alarmed if detected.

Eaton operates an independent development center, the ‘Cybersecurity

Center of Excellence’ (CCoE), specifically designed to combat the threats

posed by cyber attacks. All Eaton products are regularly qualified for

secure operation.

The XV-102 devices with an Embedded Linux operating system

seamlessly integrate into Eaton CCoE’s ‘Defense in Depth’ cybersecurity

concept. The devices boot from a write protected memory, and only

operating system software updates signed by Eaton can be installed

on the devices. All device settings and interfaces are secured via

password entries, which also withstand a brute force attack.

Communication channels can be selectively activated and encrypted

for the required tasks. However, cybersecurity and usability are not

mutually exclusive. Guided by the first-boot agent, the prepared

application software and device configuration are installed easily and

efficiently via a USB memory during machine or system commissioning.

The application software and process data can optionally be installed

on an encrypted SD card, and in the event of a device replacement,

the application-specific data can simply be taken over to the replacement

device.

EATON SDN90186 MOTOR CONTROL CENTER

EATON CEAG CU CG-S , 40071360300 Control Unit

Moeller XV-230-57CNN-1-13-1 HMI PLC Panel Touchscreen 5.7" Operator Terminal

Eaton Cutler-Hammer HFD3030 6639C86G87 3 Pole 30A 600V Circuit Breaker

Eaton HFD3150 3P 150A 600VAC Circuit Breaker

EATON MP-3000 66D2032GX1 NSNP

EATON XV-102-B5-35TQR-10-PLC 140021 XV102B535TQR10PLC

NEW EATON ELECTRIC CAN-16DO/0.5A-PK 140254 CanOpen digital output 0.5A

Eaton WL-35717F Vacuum Interrupter WL35717F

Eaton MFD-CP8-NT Central processing unit/power supply unit

Eaton MP-3000 Motor Protection Relay

Eaton HMCP400R5 HMCP400R5 Circuit Breaker

CUTLER HAMMER / Eaton 7801C57 Digitrip Optimizer Hand Held Programmer

Eaton HMCP150U4 molded case circuit breaker accessory motor protection