Beckwith Electric M-2406 Recloser Control Adapter Chassis

Adapts M‑7679 R‑PAC to Retrofit Eaton Cooper Form 6 Controls for Use

with 14‑, 19‑, or 26‑Pin Eaton Cooper Nova Reclosers

• Provides easy direct mechanical replacement of the Eaton Cooper

Form 6 recloser control in the existing cabinet

• Eliminates the need of expensive rewiring of I/O signals by

interfacing with the existing electronics

• Accepts the existing communications connection plugs for Serial

TIA‑232. TIA‑485 Ethernet and IRIG‑B

• Includes an on‑board Module that interfaces the M‑7679

R‑PAC with the power supply and battery charger installed

in the existing cabinet

The M-2406 Adapter Chassis combines with the M-7679 R-PAC for

convenient replacement of Eaton Cooper Form 6 Type F6-P2A and

F6-P2B controls (serial numbers above 10.000 or beginning with

CP57) and Triple-Single controls for 26-pin reclosers.

Please contact Beckwith Electric for solutions to retrofit controls that

are not listed here.

The M-2406 is a direct retrofit chassis designed for a simple, quick

exchange in the existing control cabinet. The M-2406 contains all

necessary components to provide proper power and control for the

Eaton Cooper Nova Recloser. Power and control functions utilize the

existing wire harnesses. The M-2406 Adapter Chassis is mounted into

the Eaton Cooper Form 6 control location using the existing hardware.

The M-2406 includes an Analog to Digital Interface Module to provide

the following, via S-7600 IPScom communications software:

• Battery voltage monitor and power shutdown

• Battery charging mode monitor

• Battery load test (manual and automatic, based on schedule)

• Battery shut down and wake up

The M-2406 is available in two configurations:

• M-2406 for 14- and 19-pin reclosers,

• M-2406-26 for 26-pin reclosers.

Optional Intrusion Detection Kit B‑1929 (requires extended I/O)

The optional Intrusion Detection Kit can be added to the Cooper Form 6

enclosure to allow a DNP point (Input 10 Status) to be monitored via

SCADA. The kit is added to the enclosure using the existing mounting

studs, and requires no special modifications. The kit consists of two

Micro switches for the front and back door, two mounting brackets, four

connection wires, and all necessary hardware.

Physical

Size with M-7679 R-PAC: 8.50" high x 10.75" wide x 7.84" deep (21.59 cm

x 27.31 cm x 19.91 cm)

Approximate Weight: 1 lb, 10 oz (0.75 kg)

Approximate Weight with M-7679 R-PAC: 6 lbs, 12 oz (3.06 kg)