Beckhoff ELM2744-0000 | EtherCAT Terminal, 4-channel solid state relay output

The ED2889 digital output terminal connects the binary 24 V DC control

signals from the automation device on to the actuators at the process

level with electrical isolation.

The EtherCAT Terminal has 16 channels that indicate their signal state

via light emitting diodes (status LEDs). The power contacts are looped

through internally. In the ED2889 the outputs are supplied via the 0 V

DC power contact. 

The connection technology is optimized for single-ended signals (common

reference point). To ensure error-free operation, all connected components

must use the same reference as the ED2889 terminal.

The EL2904 TwinSAFE component is a digital output terminal with

four channels. It switches 24 V DC actuators with up to 0.5 A per

channel and has four fail-safe outputs. The outputs are controlled

by a TwinSAFE Logic-capable component via FSoE.

The component automatically switches off if it detects an error

(fail-stop).

The EL2904 has safety parameters to specifically adapt the

functionality to the respective safety requirements.

For example, a current measurement at the outputs and a test of

the outputs can be configured in order to be able to detect cross

-circuits among other things and to react appropriately.

In addition, standard outputs can be activated for the EL2904.

As a result, corresponding standard outputs are available in the

process image in parallel and internally ANDed with the safe

outputs of the EL2904. The safe output signals, which are controlled

by a TwinSAFE Logic, thus issue the safe release for the standard

signals, which can be triggered by the non-safety oriented control

system independently of the cycle of the safety controller and FSoE.

This allows faster switching times of the outputs, provided that

the safety controller issues the necessary release for the output.

The safety parameters are not stored directly on the component,

but are transmitted to the component via a TwinSAFE Logic capable

component when the safety application is started.

This simplifies service procedures, because the component can simply

be replaced. The safety-relevant parameters are transferred to the new

component when the safety application is restarted.