ABB 5SGY35L4510 IGCT thyristor module

It is possible to select scalar control as the motor control method instead of Direct

Torque Control (DTC). In scalar control mode, the drive is controlled with a frequency

reference. However, the performance of DTC is not achieved in scalar control.

It is recommended to activate the scalar motor control mode in the following

situations:

• In multimotor drives: 1) if the load is not equally shared between the motors, 2) if

the motors are of different sizes, or 3) if the motors are going to be changed after

motor identification (motor ID run)

• If the nominal current of the motor is less than 1/6 of the nominal output current of

the drive

• If the drive is used without a motor connected (for example, for test purposes)

• If the drive runs a medium-voltage motor through a step-up transformer.

In scalar control, some standard features are not available.

Data recorder (optional)

The data recorder can log analog inputs, digital inputs, and digital out

puts. The recorder has the following settings:

•  number of samples (6-72)

•  recording period (5-60 sec)

•  pre-trigger (0-100%)

•  trigger event (start for recorder)

•  trigger event (stop for recorder)

This product is designed to be connected to and to communicate information and

data via a network interface. It is Customer's sole responsibility to provide and

continuously ensure a secure connection between the product and Customer

network or any other network (as the case may be). Customer shall establish and

maintain any appropriate measures (such as but not limited to the installation of

firewalls, application of authentication measures, encryption of data, installation of

anti-virus programs, etc) to protect the product, the network, its system and the

interface against any kind of security breaches, unauthorized access, interference,

intrusion, leakage and/or theft of data or information. ABB and its affiliates are not

liable for damages and/or losses related to such security breaches, any

unauthorized access, interference, intrusion, leakage and/or theft of data or

information.

Woodhead 1200870243 Nano-Change 3-Pole Male-Female Connector Cord 443031A10M010

Sealed Woodhead 67-0300 Closure Cap Micro-Change® (M12)

Daniel Woodhead 8R4A00A18A120 Micro Cordset 0.3m

SCHENCK T81 / T81 

SCHENCK VSE20900 EXPANSION MODULE ID61303 UP TO 24 MONTHS WARRANTY

Schenck Rtn0  05 68t RTN 68T 

Schenck Stock V505992.B13 Right Angle Worm Gear Reducer 4.438hp 200:1

14520 SCHENCK B&R TOUCH PANEL  5D5212.06 CAB 850

CV04A Air Lock Schenck. 10"

Schenck 5AP920.1505.K1 1 Rev.J0 Operator Interface Panel | Automation Panel 900

Schenck Pegasus 25C Servo Valve PLS 4424 NOS

SCHENCK RTN0 05 RING TORSION LOAD CELL 00282CE3 822005405 

Schenck A5015TFT017-01 Control Panel Industrial Panel

Schenck K001595 I/O Slide-In Module Slide-In Module with Cards

SCHENCK VEG20450 VPB8020 V039971.B01 wo

SCHENCK VNT0450 V054017.B01 zt

Schenck vs-168 sensor Schenck vs-168 sensor Schenck vs-168 sensor Schenck vs-168

Schenck Weighing Terminal DTA 404 Weighing Terminal Disomat DT Scale Display

Stock Schenck Process Group V37996-B01 Gear Reducer   Ratio1500:1  4905 In-Lbs