Woodward 9907-898 GSOV25HT Gas Fuel Shutoff Valve, 2.0” Flange

All shielded cable must be twisted conductor pairs with either a foil or a braided

shield. All signal lines should be shielded to prevent picking up stray signals from

adjacent equipment. Connect the shields as shown in the plant wiring diagram

(Figure 2-1). Wire exposed beyond the shield must not exceed two inches. The

other end of the shield must be left open and insulated from any other conductor.

Do not run shielded signal wires with other wires carrying large currents. See

manual 50532. EMI Control in Electronic Governing Systems, for more

information.

Installations with severe electromagnetic interference (EMI) may require shielded

cable run in conduit, double shielded wire, or other precautions. Contact

Woodward for more information.

Up to two Remote RTN modules may be installed into each MicroNet Plus 8/14 expansion chassis (only

one RTN for 6/12 slot expansion chassis). When initialized by the main chassis CPU, the Remote RTN

modules will acquire either a SYSCON or STANDBY status. The Remote RTN module that becomes

SYSCON will control the expansion chassis where it is located. It will synchronize with the STANDBY

Remote RTN module and perform any redundancy functions as necessary. Input and output data from all

I/O modules will be managed appropriately and made available to the GAP Application running in the

main-chassis CPUs.