schneider 499NES27100 - Quantum modlue

Hardware Structure of Distributed Input/Output Modules

TBX modules

There are three types of TBX remote input/output modules:

 Monobloc TBXs (seepage26) comprising only one element, which cannot be extended (IP20),

 Sealed TBXs (seepage26) comprising only one element, which cannot be extended (IP65).

They have 8 inputs, 8 outputs, 16 inputs or 16 outputs,

 Modular TBXs (see page 31) assembled by the user by combining a communication module

and a base unit, which constitutes a basic module (IP20).

This base can be extended by a second base, using a connection cable and equipped with a

cap connected to the communication module.

This enables the number of TBX connection points to be doubled.

The modular structure and ability to mix modular TBXs means that they can be better adapted

to the requirements of the cell.

Discrete monobloc TBX modules (IP20)

General

Discrete monobloc TBX modules (IP20) consist of either 16 discrete 24 V DC inputs, or 16 discrete

0.5 A transistor outputs, protected against overload and short-circuits, or 16 relay outputs. They

cannot be extended.

The Fipio connection point address assignment is set by 8 dip-switches (the 3 most significant dip

switches are not set), allowing up to 31 monobloc modules to be connected to the bus; Address 0

is reserved for the PLC (see Premium and Atrium Using EcoStruxure™ Control Expert, Fipio Bus,

Setup Manual). A display block indicates locally the status of the module and its inputs or outputs.

At a Glance

TBX monobloc modules have the following components:

 An element which groups together the communication electronics and the input and/or output

interfaces (1),

 a removable terminal block (2) enabling the sensors or preactuators to be connected directly to

the 16 discrete inputs/outputs of the module. The necessary power supplies are also wired to

the terminal block.

At a Glance

Sealed discrete TBX modules comprise only one element which includes the communication

electronics and the input or output interfaces, depending on the model.

Each channel is fitted with an M12 5-pin female fast connector.

The output module has a power supply connector which is used to supply the outputs and the

loads.

AEG Modicon Cutter Electric Central Unit ALU200 AS-BALU-200

Aeg Control 6051-042.23964 2 System ALU 150 CPU Dws451/99de Revision 12

DAP216N AEG Modicon/ AS-BDAP-216N digital output 2x8 24VDC, 0.5A current FR

Modicon AEG 0984-385 120/240V

AEG Modicon 110-093 Cyberline 1000 CL113 Brushless Servo Drive 110093 Gould

AEG Modicon 110-092 Cyberline 1000 CL112 Brushless Servo Drive 110092 Gould

Gould Modicon AS-B005-800 Circuit Board AS-B875 Analog Output PLC B007-800 AEG

MODICON AEG ADU 206 6728-042.27490 5 Rev. 18 4 Analog Input +10V/+20mA

SCHNEIDER AEG GOULD MODICON PLC INPUT MODULE MODEL DEP215/AS-BDEP-215

AEG DEA202-B Modicon

AEG Modicon Cutter Electric PLC A500 Digital Output Output Card DAP001 DAP

AEG AS-C921-100 INTERFACE MODULE COMM. PROCESSOR REV A ASC921100

AEG Modicon 170 bdi 356 00 Interbus TIO Module 042 703 807

Modicon TSX P5730 Processor TSXP5730