schneider 499NEH14100 - Quantum modlue

Hardware Structure of Distributed Input/Output Modules

TBX modules

There are three types of TBX remote input/output modules:

 Monobloc TBXs (seepage26) comprising only one element, which cannot be extended (IP20),

 Sealed TBXs (seepage26) comprising only one element, which cannot be extended (IP65).

They have 8 inputs, 8 outputs, 16 inputs or 16 outputs,

 Modular TBXs (see page 31) assembled by the user by combining a communication module

and a base unit, which constitutes a basic module (IP20).

This base can be extended by a second base, using a connection cable and equipped with a

cap connected to the communication module.

This enables the number of TBX connection points to be doubled.

The modular structure and ability to mix modular TBXs means that they can be better adapted

to the requirements of the cell.

Discrete monobloc TBX modules (IP20)

General

Discrete monobloc TBX modules (IP20) consist of either 16 discrete 24 V DC inputs, or 16 discrete

0.5 A transistor outputs, protected against overload and short-circuits, or 16 relay outputs. They

cannot be extended.

The Fipio connection point address assignment is set by 8 dip-switches (the 3 most significant dip

switches are not set), allowing up to 31 monobloc modules to be connected to the bus; Address 0

is reserved for the PLC (see Premium and Atrium Using EcoStruxure™ Control Expert, Fipio Bus,

Setup Manual). A display block indicates locally the status of the module and its inputs or outputs.

At a Glance

TBX monobloc modules have the following components:

 An element which groups together the communication electronics and the input and/or output

interfaces (1),

 a removable terminal block (2) enabling the sensors or preactuators to be connected directly to

the 16 discrete inputs/outputs of the module. The necessary power supplies are also wired to

the terminal block.

At a Glance

Sealed discrete TBX modules comprise only one element which includes the communication

electronics and the input or output interfaces, depending on the model.

Each channel is fitted with an M12 5-pin female fast connector.

The output module has a power supply connector which is used to supply the outputs and the

loads.

Schneider AEG Modicon AS-B865-001 Register Input Module ASB865001

AEG MODICON AS-B827-000 ASB827000 INPUT MODULE

AEG Modicon Isolated Output Module AS-B810-008 115VAC

AEG MODICON AS-B806-032 OUTPUT MODULE P/N: AS-8713-000 OUTPUT MODULE 120 VAC

AEG Modicon AS-B351-001 PLC Input Module Schneider Electric Gould

AEG MODICON PC-0984-680 P/N AS-9370-001 PROGRAMMABLE CONTROLLER 115/220V 50/60Hz

Modicon AEG Output Module 1-DO-1132-000 Ser. A_1DO1132000_1 -D0-1132-000

AEG 140DAI55300 Modicon Input Module 115V

AEG 140CPS11400 Modicon Power Supply Module 230V 10A 50/60Hz

AEG Modicon 140-AVO-020-00 An OUT 4-CH Voltage Analog Output Module

MODICON/ AEG 110-108 MODEL PLS4 POWER SUPPLY, REV W4

AEG MODICON MICRO 110CPU61200, 043502596

Modicon AEG Model 380 Programmable Controller PLC Module PC-0984-380