ABB NKTU02-13 I/O Module to Termination Module Cable

I/O Module to Termination Module Cable Manufacturers ABB

Bailey Model(s) ABB Bailey Infi 90, ABB Bailey Infi 90 and Net 90

Additional Information I/O Module to Termination Unit Cable, NKTU11-09

Connects I/O Module to Termination Unit, 09 feet long, non-PVC

Estimated Shipping Size Dimensions: 0.0" x 0.0" x 15.0" (0.0 cm x 0.0 cm x 38.1 cm)

Weight: 0 lbs 6.1 oz (0.2kg )

Tariff Code: 8544429000

Country of Origin: United States Ships from Webster NY, USA

I/O Module to Termination Module Cable

Symphony Plus Control & I/O BRC410

ƒ Performance increase depends on specific

function blocks used, but in general

performance of latest module (BRC410)

compared with older modules:

ƒ ~ 10x vs. MFP01/02/11/12

ƒ ~ 4x vs. BRC100/200

ƒ Enhanced On-Line Configuration provided

by BRC410

ƒ BRC410 also provides ModBus TCP

ƒ BRC410 support 30,000 block addresses

and 4,000 Modbus TCP/IP points

ƒ Infi90 Modulebus support*

ƒ Downloadable firmware 

Features and benefits

Termination for up to eight (8) analog I/O process signals within a horizontal row.

All SD I/O modules & bases of all types (Singular or Redundant) AND (Compact or Full-size), are

100% fully compatible with each other. Thus, Singular & Redundant, Compact or Full-size I/O

modules can be mounted within a single, common HN800 I/O bus.

Optional mechanical keying can be implemented to prevent insertion of the wrong I/O module type.

Latching device on the base locks the base into position on DIN-Rail.

Industry standard 35-mm DIN rail, Horizontal row mounting.

Below is a side internal view of the EL mechanism and the associated anti-pumping component. 

When the opening pushbutton or coils are activated the opening shaft lever pushes down on point C of the anti-pump device.

This causes the device to side down slot D in direction of arrow B. 

Then the trigger portion A moves out from between the closing push-button and the closing shaft lever. 

So if the closing button or signal is held active and the opening button or signal is then activated.

The trigger A will pull out from between closing shaft lever and the closing push button. 

Once the open signal is released the trigger A will come to rest under the closing push-button and will 

not return between the closing shaft lever and closing push-button until the button or closing command is released.

The closing push button is operated by the closing coil (MC) directly by the shaft closing device.

This allows the anti-pumping device to prohibit closing by manual or electrical means.

You may need the following additional products：