Johnson Controls DIS1710 Local Controller Display Installation Instructions

Applications

The DIS1710 Local Controller Display is a stand-alone display module designed

for installation on the front panel of an enclosure. The DIS1710 display can

connect to the Network Control Engine (NCE), Field Equipment Controller (FEC),

or Advanced Application Field Equipment (FAC) models that do not have integral

displays. The display provides a local user interface for the application running in

the controller. Use the Controller Configuration Tool (CCT) tool to configure the display.

North American emissions compliance

United States

This equipment has been tested and found to comply with the limits for a Class A

digital device pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when this equipment

is operated in a commercial environment. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area may cause harmful interference,

in which case the users will be required to correct the interference at their own expense.

Canada

This Class (A) digital apparatus meets all the requirements of the Canadian

Interference-Causing Equipment Regulations.

Cet appareil numérique de la Classe (A) respecte toutes les exigences du Règlement

sur le matériel brouilleur du Canada.

Installation

• Observe these guidelines when installing the DIS1710 display:

• Transport the display in the original container to minimize vibration and shock damage

to the unit.

• Verify that all parts were shipped with the display.

• Do not drop the display or subject it to physical shock.

Parts included

• One DIS1710 Local Controller Display

• One communication cable

• One O-ring

• One installation instructions sheet

Materials and special tools needed

• Power saw for cutting a hole into the panel to hold the display, if no hole is provided

• Small Phillips-head screwdriver