Trademark Information
ComfortPointTM Open is a trademark of Honeywell
International Inc.
BACnet® is a registered trademark of ASHRAE Inc.
UL Logo, FCC statement, and the CE Mark Logo are used to
indicate product compliance and/or conformance to those
standards. These Logo/Marks are trademarks of the
respective agencies.

GENERAL
• Native BACnet series of controllers with direct-coupled
damper actuator and de-clutch mechanism
• CPO-VAV2A-US firmware is based on B-AAC BACnet
profile
• Outstanding performance with 32 bit technology
• Uses standard VAV application or flexible custom
programming
• Built-in Real Time Clock
• Connects to one of three BACnet MS-TP channels of a
ComfortPoint Open Plant Controller
• Supports Sylk® communication
• Fully integrated with ComfortPoint Open Manager and
Enterprise Buildings Integrator (EBI)
• Flexible and easy configuration with ComfortPoint Open
Studio and quick VAV Balancing with ComfortPoint Open
online tool
FEATURES
Freely Programmable Native BACnet Controller
CPO-VAV2A-US is a freely programmable native BACnet
controller.
Onboard Input and Outputs
CPO-VAV2A-US comes with 4 UI, 3 AO and 6 DO (2 DO
reserved for internal actuator) with an integrated air flow
sensor.
Sylk® communication port
Two-wire polarity-insensitive bus interface provided to connect
Sylk® devices.
Actuator integrated
Vertically integrated with series 60 actuator with Torque Rating
5 Nm, 95 degree stroke, and 110 sec. Timing at 50 Hz and 90
sec at 60 Hz.
Supports de-clutch mechanism to enable the installer to open
or close the VAV box damper manually without power or
software tool.
Support round (8mm to 16 mm) or square (6mm to 13 mm)
shafts. Noise 35 dBA at 1 meter maximum.
VAV Applications
ComfortPoint Open Studio tool comes with predefined VAV
Applications which can be downloaded to CPO-VAV2A-US.
The Tool allows spare points programming as per user needs.
Programming and Balancing
CPO-VAV2A-US can be programmed using ComfortPoint
Open Studio. Balancing is done via ComfortPoint Open Online
which allows online discovery of VAV devices on the BACnet
MSTP channel.
Easy installation
The ComfortPoint Open plant controllers have a built in
BACnet router which eliminates the need for additional
BACnet routers for the system. ComfortPoint Open Manager
and EBI can access all MSTP Unitary controllers via CPO-PC
6A, CP-IPC, or CP-Core BACnet router built-in ComfortPoint
Open plant controller.
wechat/whatsapp:
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved