Honeywell IntelliDoX Automated instrument management system

Get more from your gas detector with unmatched performance and

customization. The IntelliDoX system combines smart docking modules

and device management software to provide automated instrument

management for compatible detectors, helping you drive productivity,

reliability and efficiency.

Fast instrument management and enhanced productivity.

IntelliDoX is easy to install, taking under 2 minutes from setup of a

five‑module dock to the bump of your first instrument. Each module has

its own operating system, LCD screen and internal pump allowing you

to perform more than one operation at the same time.

Whether you want to bump three detectors or calibrate others – you can

get more done in less time.

Flexible configuration to meet changing needs

Configure the low and high alarm set points – plus other detector parameters

– throughout the lifespan of the detector. So you can rely on your detector to

always work the way you want it to.

Efficient networking and data transfer for easy record‑keeping

Use either USB or Ethernet to transfer bump tests, peak exposures and

other gas‑detection data.

• A new level of customization for device management

• Configure alarm set points, track compliance of workers and more

• Flexible docks and software – expandable to five modules

• Quick and easy setup – great for turnarounds

Compatible Detectors

• Honeywell BW® Clip Series

• Honeywell BW™ Solo

• Honeywell BW™ Clip4

• Honeywell BW™ MicroClip Series

• Honeywell BW™ Ultra

• Honeywell BW MaxXTII

Options & Accessories

Multi-Inlet Key – Configure a single IntelliDoX module to connect

multiple calibration gas cylinders

FEATURES & BENEFITS

• Industry-leading FastBump test that eliminates bottlenecks,

while avoiding costly purge cycles that waste gas

• Gangable up to five modules, each with its own LCD screen and

keypad for independent operation

• Easy to set up with no tools required

• Easy to connect via Ethernet to a network

• USB port to easily configure dock module settings or

retrievedata without network access

• Automated bump test and span calibration operation

• Device management with Safety Suite Device Configurator

• Modular nests for device changes

• Bump testing, calibration, configuration, and record-keeping

support for compatible detectors.User updatable settings:

- Configure alarm settings

- Display gas reading during alarm

- Enable non-compliance indicator

- Hibernate detector

- Schedule bump test and calibration reminders

- Transfer event logs

- Time display preferences

- Update firmware