GE IS210JPDEG1A - POWER DISTRIBUTION BOARD

Part Number IS210JPDEG1A Manufacturer General Electric Country of Manufacture As Per

GE Manufacturing Policy Series Mark VI Function Module Availability 

IS420UCSBH4A Module manufactured by General Electric as part of the Mark VI/VIe Series

used in gas turbine sppedtronic control systems View More IS220PSCAH1B Module

manufactured by General Electric as part of the Mark VI/VIe Series used in gas turbine sppedtronic

control systems View More IS220PDIAH1B Module manufactured by General Electric as part

of the Mark VI/VIe Series used in gas turbine sppedtronic control systems View MoreModule manufactured

by General Electric as part of the Mark VI/VIe Series used in gas turbine sppedtronic control systems

• 8 isolated, universal, input channels

• Configurable on a channel by channel basis: 4-20mA, THC, RTD, resistance &voltage

• 250V ac rms channel to channel isolation

• Thermocouple types B, E, J, K, N, R, S, T, W3. W5. Russian K, Russian L

• RTD Types Pt100. jPt100. Pt200. Pt500.Ni120. Cu10

• Volt input types ±120mV, 0-1V, 0-5V,1-5V, 0-10V, ±10V

• 2 or 3-wire RTDs

• 2 or 4-wire transmitters

• Non-incendive field circuits

• 24 V dc bussed field power required

Ease of Use 

A range of features are provided to simplify the day-to-day operation of a Process Automation System: 

– Controllers feature numerous LEDs to assist with fault finding. 

– Controllers report failed power supplies when used in conjunction with PAC8000 AC power supplies and the 8410-NS-PS nodes services module. 

– On replacing an IO module, the Controller will automatically bring it online if it recognizes the type as being correct. 

– Online download of new application programs is possible with simplex controllers, and online download of new firmware is often possible with redundant controllers. 

– PAC8000 controllers feature an RS485 serial connection for Modbus RTU communication (a second serial connection can be made on the Controller Carrier). 

– When used with the dedicated AC Power Supplies, PAC8000 nodes can be configured to “warm start” after power failure 

– the power supplies provide sufficient hold up time for the controller to store all necessary live data and to re-commence control from the point the power was lost, when it is restored.

Tradeoff of Resolution for Module Throughput

The module offers ~15 bit effective resolution on all

channels. The module also offers several analog-to

digital conversion options that allow higher speed

signals to be selectively read more quickly on a

channel-by-channel basis.

Note however, that at the highest speeds, uncertainty

in value of the lower bits will increase, resulting in

reduced resolution. The following table indicates the

approximate effect on resolution of higher speeds.