GE IC800SSI228RD2 Applicable MTR-Series Servo Motor

The S2K Series controllers are optimized for use with the GE Fanuc S-Series or MTRseries servo and stepping motors. 

Overload and possible component damage may occur if the motor and amplifier are not properly matched.

Tables 1-1 to 1-3 show the recommended pairing of the components. 

The S2K Series stepper controller requires a single-phase 115 VAC supply. 

S2K Series servo controller models rated 230 VAC and 4.3 or 7.2 amp can operate on either 115 VAC single-phase or 230 VAC three-phase, 

while the all other models are rated for three-phase input. 

The 230 and 460 VAC models are intended to be operated from a three-phase supply but can be used with a single-phase power source. 

The S-Series servo motors optimized for use with the S2K Series controllers range from 30 W to 5 kW and are rated for 230 VAC for full speed. 

Using a 115 VAC supply will result in a reduced operating speed of approximately one half of the rated speed. 

The 30 to 1,000 Watt S-Series servo motors (SLM models only), 

MTR-3S and MTR-3N series and all stepping motor models are designed with standard NEMA shaft 

and flange mounting configurations for easy mounting to off-the-shelf gear reducers and couplings. 

The 750-Watt S-Series motor uses an oversized shaft diameter (0.625 inches) for the NEMA 34 

mounting in order to handle the peak torque rating of this model.

S-Series motormodels from 1 to 5 kW (except the SLM100 1kW motor) and all MTR-3T Series motors have metric mounting configurations 

All servo motors are available with an optional 24 VDC holding brake.

These brakes are spring-set, electrically released models designed for holding stationary loads.

The user must supply a separate 24 VDC brake power supply. 

The 30-750 Watt S-Series motors have a pigtail cable with box style connectors for motor power, encoder and brake connections. 

The 1,000 to 5,000 Watt S-Series motors have MS style connectors and the brake power (when required) is 

integrated with the motor power connections in a common connector/cable. 

MTR-series servo motors include MS type connectors for brake power input.

The MTR-3N and MTR-3T series brake motors integrate the brake power with the motor power in the same cable. 

MTR-3S brake motors require a separate brake power cable (CBL-30-BT). 

S2K Series controllers are configured and programmed using the Motion Developer software for a personal computer. 

This software is a standalone application that works within the Machine 

Edition software environment and provides tools to simplify programming for the novice

while providing direct code entry for the advanced user. 

The following sections outline what should be accomplished before operating the S2K Series controller.