GE IS210SCSAS1A - SCSA ASSEMBLY, MARK VIES

Part Number IS210SCSAS1A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI Function Module Availability In StockIS420UCSBH4A Module manufactured by General Electric as part of the Mark VI/VIe Series used in gas turbine sppedtronic control systems View More IS220PSCAH1B Module manufactured by General Electric as part of the Mark VI/VIe Series used in gas turbine sppedtronic control systems View More IS220PDIAH1B Module manufactured by General Electric as part of the Mark VI/VIe Series used in gas turbine sppedtronic control systems View MoreModule manufactured by General Electric as part of the Mark VI/VIe Series used in gas turbine sppedtronic control systems

Wiring Information

You must purchase the mating female (socket type) 24-pin connectors (which mate with the I/O Connector on the faceplate of the APM). 

This connector is available under catalog number IC693ACC317. 

This connector has a solder eyelet receptacle and is part of an accessory kit. Optionally, 

other types of the 24-pin connector (for different physical connections) are also available. 

Catalog numbers for these connectors and their associated parts are listed in the following table. 

The list includes catalog numbers for three types of connectors: solder pin, crimp pin, and ribbon cable. 

Each accessory kit contains enough components (D-connectors, backshells, contact pins, etc.) 

to assemble ten single-ended cables of the type specified for each kit.

System Configurations

The Mini Converter can be used in a point-to-point configuration as described above, 

or in a multidrop configuration with the host device configured as the master and one or more programmable controllers configured as slaves.

The multidrop configuration requires a straightthrough (1-to-1) cable from the Mini Converter’s RS-422 port to the first slave PLC’s SNP port.

Other slaves will require a daisy chain connection between slaves. 

A maximum of eight devices can be connected in an RS-422 multidrop configuration.

All of the devices must have a common ground. 

If ground isolation is required, you can use the Isolated Repeater/Converter (IC655CCM590) in place of the Mini Converter.

When using the Mini Converter with a modem connection, 

it may be necessary to jumper RTS to CTS (consult the user’s manual for your modem).

Cable Diagrams (Point-To-Point) When connecting the Mini Converter to IBM PC and compatible computers with hardware handshaking,

the following cable connections should be used.