ALSTOM ALSPA®MV500 Drive Easy to use – Simple to install

Easy to use – Simple to install

The new ALSPA MV500 drive from ALSTOM Power Conversion brings reductions

not only in drive costs but,equally as important nowadays, reductions in complexity. 

No drives knowledge is required to install and use MV500 in most applications,

ideal for today’s busy process engineer.

In addition to straightforward installation, ALSPA MV500 provides ease of operation

with just10 para meter settings covering most drive applications.

For more complex applications, additional,menus are available if required.

Complex features such as PID control and multi motor control,usually only found

on larger drives, are built into MV500 waiting for configuration via the serial link.

• Simple installation and start up

• Models available for 230V and 400V operation, single and three phase input

• Most drive applications covered by just 10 parameters

• Advanced menus for applications not available from other small drives

• Fast installation and convenient cable management

• Non shaft rotating autotune assists fast set up

• RS485 serial communications as standard

• Intelligent thermal management ensures minimum motor noise with maximum drive protection

• Large power terminals for ease of cabling

• Pluggable terminals for fast access

• Model sizes 2-4 have built-in braking transistor for fast dynamic braking

• Easy options:

- Cloning module for rapid, accurate parameter transfer

- Full EMC compliance with space saving filters

- Future proof fieldbus compliance

- PC Windows® based set up software for advanced configuration

- IP65 multi-language remote keypad