The 2500P-ECC1 provides two Ethernet ports capable of operating at 10 or 100Mb, half or
full duplex. The speed and duplex mode are automatically negotiated with the device
connected to the port. Each port supports auto-crossover capability, allowing the port to be
connected to an external Ethernet switch or directly to a device, such as a laptop or 2500
Series® controller. Both ports are functionally equivalent.
The Ethernet ports are connected to an Ethernet switch incorporated into the 2500P-ECC1
module. This switch is also connected to the Ethernet controller on the ECC1
microprocessor. This arrangement allows devices connected to either port to communicate
with the microprocessor and allows communications between ports. The switch also
provides hardware protection against excessive broadcast/multicast traffic.

HARDWARE FEATURES
• Front display for IP address and error messages
• Four Ethernet ports can be configured with up to four unique network addresses
• Internal SD card contains entire operating system, firmware, user program, configuration,
user data (NOTE: This allows rapid replacement of a failed CPU simply by
transferring the old SD card into the replacement unit)
• External SD card for file exchange, firmware update, initial IP address assignment
• Front-accessible battery
The 2500P-ECC1 Ethernet Communications Coprocessor provides state-of-the-art
features and performance for Ethernet communication when using CTI 2500
Series® Processors. It uses a dynamic memory cache to give extremely quick
response to queries from HMI systems, with no dependence on CPU scan time.
It also provides a fully configurable interface for setting up Modbus-TCP, and
CAMP client/server communications. Most importantly, it features a completely
new facility which provides peer-peer network communications between PLCs
using a new "report on change" protocol - Network Data Exchange.
WOODHEAD SST-DN3-PCU-2( E) PCI DEVICENET INTERFACE CARD DN3-PCU-2(E) V1.2.8
SST Woodhead SST-ESR2-CLX-RLL Ethernet Modbus/Serial Modbus Communication
Woodhead PB3-PCIe 2 SST-PB3-PCIE 1 V1.1.0 Communication card
MOLEX SST-DN4-PCIE-H / SSTDN4PCIEH
SST 5136-PFB-PCI Profibus Communications Adapter Module
CTI 901B-2500-RBC Profibus Remote Base Controller
CTI 901B-2500-RBC Profibus Remote Base Controller
CTI Control Techniques 901D-2500-RBC Profibus Remote Base Controller
CTI 2500-RIO-B RS485 Remote Base Controller
CTI 2500C-RBC-RS485 RS485 Remote Base Controller
CTI Control Technology 901E-2589-A Input Module PCB
WOODHEAD SST DHP-PCI V1.2.0 SD-PCI-U DATA HIGHWAY PLUS INTERFACE CARD
Molex SST-PB3-VME-2 Brad Communication Board SSTPB3VME2E
AMAT 0190-34511 REV. 08 SST woodhead DNet bus scanner DNPCPCI3U1-NC- 3V V1.3.4
WOODHEAD SST-DN3-PCU-1 DEVICENET INTERFACE CARD
SST / WOODHEAD 5136-PFB-VME PROFIBUS INTERFACE CARD 5136PFBVME NIB
| User name | Member Level | Quantity | Specification | Purchase Date |
|---|
wechat/whatsapp:
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved