GE IC800SSD216RS1-DB S2K Series Drives

Cables and Connector Mates

Cables in several lengths are available from GE Fanuc for motor to controller connections and various other controller functions.

It is strongly recommended that you use the cables  available from GE Fanuc as shown in Table 3-15.

GE Fanuc does not provide mating  connectors for the MTR-Series motors or S-Series motors along with the motor; 

you can,  however, purchase the S-Series and MTR-3T Series motor connector kits, 

shown in table 3- 16, from GE Fanuc.

Note: GE Fanuc cables and connectors shown are not rated for IP67 environments, 

or  washdown applications. GE Fanuc cables are not designed for high flex or cable  track applications.

Analog Output (AO)

The hardware analog output is primarily used as a process input to the controller programs,

but it can also be used a diagnostic output for various signals used in the tuning and

debugging process. The Analog Common pin is used for the signal return. The Analog

Output (AO) software parameter allows you to configure this output to represent one of the

following signals:

• Actual velocity (AO = VLA)

• Actual output current (AO = CMD)

• Following error (AO = FE)

Stepper Controller Electrical Specifications

The S2K Stepper Controller (IC800STI105xx) is suitable for use on a circuit capable of

delivering not more than 5,000 rms symmetrical amperes and 130 volts maximum when

protected by RK5 class 15A fuses. Table 2-2 summarizes the Stepper Controllers

maximum continuous input power requirements. The actual input power and current is a

function of the motor's operating point and the duty cycle. 

INDUCTIVE LOAD DRIVER — Bifilar (unipolar) stepper motors can be driven directly. 

The internal kickback diodes prevent damage to the output transistors by

suppressing the high-voltage spikes which occur when turning OFF an inductive load.

We have the same series of models in stock. 

If you don't find the model you need, please contact us and we will provide you with an official quotation！