System Power-Up
If at any time during this procedure the defined or expected result is not achieved, begin system
troubleshooting.
1. Verify that the entire MicroNet Plus control system has been installed.
2. Turn on the power to one power supply and verify that the power supply’s green LED is the only
power supply LED on.
3. Turn off the power to the first power supply and turn on the power to the second power supply (if a
second power supply is present) and verify that the power supply’s green LED is the only power
supply LED on.
4. The RTN_CPUs in the chassis will not start automatically, the CPUs in the TMR chassis must
command them to start. See GAP application program for details.
For redundant operation, the control can use any combination of power supplies.
The power supplies can only be installed into slots PS1 (power supply #1) and PS2 (power supply #2). If
redundant power supplies are not needed, blanking plates must be installed in the slots not being used.
Branch circuit fuses, circuit breakers, and wiring must meet appropriate codes and authorities having
jurisdiction for the specific country (CE, UL, etc.). See Table 4-3 for maximum recommended fuse or
breaker ratings. Do not connect more than one main power supply to any one fuse or circuit breaker. Use
only the wire sizes specified in Table 4-3. which meet local code requirements. Time delay fuses or circuit
breakers must be used to prevent nuisance trips.
In the event that on supply needs to be replaced, the recommended method for changing
Power Modules is with the power off (to the module being removed and the module being inserted).
The system will tolerate this “cold swap” method without failure.
Woodward 5417-557 Configuration Cable Required |
Woodward 8440-2116 Digital Expansion Cards |
Woodward 8440-2307 Digital Expansion Cards |
Woodward 8440-2306 Digital Expansion Cards |
Woodward 8446-1007 Remote Annunciator |
Woodward 8440-2100 actiVgen |
Woodward 8445-1049 EKS CAN Fiber Converters |
Woodward 8445-1048 EKS CAN Fiber Converters |
Woodward 10-012-909 Exciter-10 DC Amplifier |
Woodward 8444-1074 LSG Load Share Gateway |
Woodward 8444-1075 LSG Load Share Gateway |
Woodward 8445-1044 ESENET CANopen to MODBUS/TCP Converter |
Woodward 8445-1046 ESEPREO CANopen to PROFIBUS-DP |
Woodward DTSC-200-51B 8440-1867 ATS Controls |
Woodward DTSC-200-55B 8440-1868 ATS Controls |
Woodward DTSC-200-55B/K38 8440-2155 ATS Controls |
User name | Member Level | Quantity | Specification | Purchase Date |
---|
wechat/whatsapp:
+86-181-4410-0983
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved