GE IS400WNPSH1A - POWER SUPPLY

Part Number IS400WNPSH1A Manufacturer

General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI Function Module Availability

Module manufactured by General Electric as part of the Mark VI/VIe Series

used in gas turbine sppedtronic control systems

Part Number IS230JPDGH1B Manufacturer

General Electric Country of Manufacture As Per GE Manufacturing Policy

Series Mark VI Function Module Availability Unisys Group. 

All Rights Reserved.Module manufactured by General Electric

as part of the Mark VI/VIe Series used in gas turbine sppedtronic control systems

Note 

A shielded motor power cable is required in CE marked systems. When used, the 

power cable shield should connect to the frame ground stud on the bottom of the 

controller and to the connector at the motor end. GE Fanuc’s standard motor power 

cables do not include a shield. 

On the 30–750 Watt S-Series motors, the power connectors shown in the following figure are wired 

to the motors with short leads and include a separate connector (and require a separate brake cable) 

when the optional holding brake is included. On the 1.0–5.0 kW motors, the MS-style connectors 

shown are mounted directly on the motor’s frame and the brake connections are included in the same 

connector and cable.

FAULT CONDITIONS — In the event of a shortedload, shorted winding, or stalled motor, the load current will attempt to increase.

As described above, the drive current to the output stage is diverted (limiting the load current to about1 A), causing the output stage to go linear. As the junction

temperature of the output stage increases, the thermal limit circuit will become operational, further decreasing the drivecurrent.

The load current (junction temperature) is then a function of ambient temperature, state of remaining drivers,supply voltage, and load resistance.

If the fault condition is corrected, the output driver will return to its normal saturated condition. 

Short circuit protection is provided for each output for supply voltages up to 25 V.

Any program can start and stop any other program, and all programs can utilize common motion blocks. 

Engineering time is reduced and integration is simplified due to configuration and programming wizards for the controller software.