ABB PHARPS00200000 Power Supply Module

Power Supply Module Manufacturers ABB, Bailey Model(s) ABB Bailey Infi 90

ABB Bailey Infi 90 and Net 90

Additional Information Modular Power System III (MPS III) 48V @ 8.5A

Estimated Shipping Size Dimensions: 0.0" x 0.0" x 0.0" (0.0 cm x 0.0 cm x 0.0 cm)

Weight: 0 lbs 0.0 oz (0.0kg )

Power Supply Module

FEATURE

• Low-impedance busbar protection 

• Stub and T-zone protection 

• High functional reliability due to two independent measurement criteria: 

- stabilized differential current algorithm 

- directional current comparison algorithm 

• Phase-by-phase measurement 

• Reduced CT performance requirements 

• High through-fault stability even in case of  CT saturation 

• Full solid-state busbar replica 

• No switching of CT circuits 

• Only one hardware version for  

- 1 and 5 A rated currents 

- all auxiliary supply voltages between  48 V DC and 250 V DC 

- nominal frequencies of 50, 60 and  16.7 Hz 

• Short tripping times independent of the  plant’s size or configuration 

• Centralized layout: Installation of hardware  in one or several cubicles 

• Distributed layout: Bay units distributed  and, in the case of location close to the  feeders, with short connections to CTs, isolators, circuit breakers, etc. 

• Connections between bay units and central  unit by fiber-optic cables 

- maximum permissible length 1200 m  

- for distributed and centralized layout 

• fiber-optic connections mean interference proof data transfer even close to HV power  cables 

• Replacement of existing busbar protection  schemes can be accomplished without restrictions (centralized layout) in the case of

substation extensions e.g. by a mixture of  centralized and distributed layout 

• Easily extensible

OTHER INFORMAITION

• The operator panel is designed for stationary installation on a planar surface, where the following conditions are fulfilled: 

– no high explosive risks 

– no strong magnetic fields 

– no direct sunlight 

– no large, sudden temperature changes 

• Install the operator panel according to the accompanying installation instructions. 

• Ground the operator panel according to the accompanying installation instructions. 

• Only qualified personnel may install the operator panel. 

• Separate the high voltage, signal and supply cables. 

• Make sure that the voltage and polarity of the power source is correct before connecting the operator panel to the power outlet. 

• Peripheral equipment must be appropriate for the application and location. 

• In a Zone 2 environment, this equipment shall be installed in an enclosure that provides a degree of protection not less 

than IP 54 or greater than IP 65 in accordance with IEC/EN 600079-0. The IP rating of the equipment is limited to the IP rating of the enclosure it is to be installed into. 

• In a Zone 22 environment, this equipment shall be installed in an enclosure that provides a degree of 

protection not less than IP 64 or greater than IP 65 in accordance with IEC/EN 600079-0.

The IP rating of the equipment is limited to the IP rating of the enclosure it is to be installed into.