ABB NKTU11-24 I/O Module to Termination Unit Cable

I/O Module to Termination Unit Cable Manufacturers ABB

Bailey Model(s) ABB Bailey Infi 90 and Net 90, ABB Bailey Net 90

Information I/O Module to Termination Unit Cable, NKTU11-8, Connects I/O Module to Termination Unit, 8 feet long, non-PVC

Estimated Shipping Size Dimensions: 17.0" x 3.0" x 17.0" (43.2 cm x 7.6 cm x 43.2 cm)

Weight: 3 lbs 0.0 oz (1.4kg )

I/O Module to Termination Unit Cable

Introduction

Harmony tag objects are configured from the TagConfig Aspect in the Control 

Structure inside the Workplace. This section describes the common aspect views of 

the Harmony objects.

TagConfig Aspect View

All TagConfig Aspect views have the same general appearance and behavior. The 

aspect views are divided into three common areas of Tabs, Body, and Footer.

Tabs

The tabs associated with the Aspect view depend on the type of object that is 

selected for Harmony. Harmony data that is common to multiple object types is 

presented in the same way to help make Harmony tasks easier and to improve 

efficiency. The General tab is included for every object type.

Body

The body area contains all of the configurable properties of any selected tab.

Footer

The footer area contains controls to apply or cancel changes.

Sending Global Alarm Acknowledgement Messages to the Loop

Enable Tag Acknowledgment Broadcast 

To broadcast an alarm acknowledgement for a specific Harmony tag: 

– Select the Tag Acknowledgment Broadcast Enable check box on the  Harmony Tab of the tag. Selecting the 

checkbox enables the connectivity server to broadcast the alarm  acknowledgement for this tag on the communication highway.  

Enable Acknowledgment Transmission 

Configure the module status tag for each node to which the connectivity server  transmits the alarm acknowledgment messages. 

For each module status tag, on the  Module tab, select the Enable Alarm Acknowledgment 

Transmission check box to  have the connectivity server transmit any recently acknowledged alarms.

Broadcasts  will only be sent to a node when the corresponding module status tag is configured  and has alarm acknowledgment transmission enabled.  

Receiving Global Alarm Acknowledgement from the Loop 

Configure the Harmony Server tag to enable receiving global alarm  acknowledgment messages from other nodes on the loop. 

On the Harmony tab, select the Global Alarm Acknowledgement check box to  

enable the connectivity server to process the Global Alarm Acknowledgement  messages received through the INFI-NET loop. 

The connectivity server applies the alarm acknowledgement to the harmony tag that  has the same Harmony address as the broadcast tag.