GE IS200SHRAH2A HART I/O TB

Refer to the Series 90-30 Programmable Controller Installation Manual, GFK-0356 for details on

power supplies and module load requirements.

The bottom LED, User Supply OK, indicates that the user provided 24V supply is within

specifications, thereby enabling the analog side of the module to work properly

This exceptional control solution is compact, cost-effective, and adaptable, serving as a compact PLC, distributed

I/O, or distributed control system. 

The 16-Channel Analog Current Input module provides up to 16 single-ended input channels, 

each capable of converting an analog input signal to a digital value for use as required by your application. 

References Used

The number of 16-Channel Analog Current Input modules which may be installed in a system

depends on the amount of %AI and %I references available. Each module uses 1 to 16 %AI

references (depending on the number of channels enabled) and from 8 to 40 %I (depending on

alarm status configuration) references.

Configuring IC693ALG223 Using Hand-Held Programmer

You can also configure the 16-Channel Analog Current Input module using the Series 90-30

Hand-Held Programmer. In addition to the information in this section, refer to GFK-0402, the

Hand-Held Programmer for Series 90-30/20/Micro Programmable Controllers User’s Manual

for more information on configuration of Intelligent I/O modules.

Although you can change the number of actively scanned channels with the Logicmaster

90-30/20/Micro configurator function, the Hand-Held Programmer does not support editing the

number of actively scanned channels. If the 16-Channel Analog Input module is initialized by

a Hand-Held Programmer, the number of actively scanned channels is 16.