Beckhoff EK1828 | EtherCAT Coupler with integrated digital inputs/outputs

The EK1501-0100 serves as a media converter from fiber optics to copper

hardware and has an SC duplex socket, an RJ45 jack and three hexadecimal

ID switches. The coupler is connected to the network via the upper Ethernet

connection. The lower RJ45 socket may be used to connect further EtherCAT

devices in the same segment. The multi-mode glass fiber connection enables

distances of up to 2 km between two couplers. A group of EtherCAT

components can be assigned a unique ID via the hexadecimal ID switches.

This group can then be located at any position within the EtherCAT network.

Variable topologies are therefore easily implementable. In addition, an EtherCAT

junction or an EtherCAT extension can be used for the extension or for setting

up a line or star topology.

The EK1300 has two P-coded M8 connections. The upper EtherCAT P

interface is used to connect the coupler to the network, the lower

P-coded M8 socket is used for optional continuation of the EtherCAT

P topology. In addition, the EK1322 EtherCAT P junction or the EK1310

EtherCAT P extension can be used for extending or creating a line or

star topology.

Since EtherCAT P integrates the power supply and the communication

on a single line, an additional power supply for the coupler via the

terminal points is no longer required. Depending on the application,

the system and sensor supply US or the peripheral voltage for actuators

UP can be bridged to the power contacts.

The EK1110-0043 EtherCAT EJ Coupler connects the compact Embedded

PCs from the CX series and the attached EtherCAT Terminals with the

EtherCAT plug-in modules on an application-specific circuit board (signal

distribution board).

The Embedded PC can be extended with EtherCAT Terminals that are not yet

available in the EJ system, for example. The preassembled subsystem, consisting

of a printed circuit board with mounted DIN rail, Embedded PC and EtherCAT

plug-in modules, can be tested in advance and subsequently integrated into

the machine assembly as a complete unit.

The EK1100-0008 EtherCAT Coupler is the link between the EtherCAT protocol

at fieldbus level and the EtherCAT Terminals. The coupler converts the passing

telegrams from Ethernet 100BASE-TX to E-bus signal representation. A station

consists of a coupler and any number of EtherCAT Terminals that are automatically

detected and individually displayed in the process image.

M/D TOTCO CCE-130K-E551- 01TG FORCE TRANSDUCER 4-20 mA

M/D Totco CCE-130K-E551-01TG Force Converter 4-20 Ma

M/D TOTCO CCE-130K-E551- 01TG Trasduttore Di Forza 4-20 mA

MTU ELEKTRONIK MDEC ENGINE CONTROL UNIT 5275306860

HYUNDAI UAN50C3C M1C1S168S AIR CIRCUIT BREAKER 3 POLE 5000A

SIEMENS 6ES7 417-4HL01-0AB0 SIMATIC S7-400 CPU MODULE

CU8815-BECKHOFF-CU8815

Beckhoff CX2030 Industrial PC 4GB | HW: 4.2 | CX2030-0155

Beckhoff CP6933-0001-0000

BECKHOFF module EL5122

Beckhoff CP7711-0001-0030 Industrial Computer Detection

BECKHOFF AX5106-0000-0200 Servo Driver

FOR Beckhoff EK9500 EtherNet/IP-Buskoppler

Beckhoff CP3918-1012-0000 Multi-Touch Control Panel 24VDC