MOOG D138-002-003 Industrial Control Module

The recognised method is to use shielded cables for all connections, the

The accepted method is to use shielded cable for all connections and to radially

terminate the cable shield with a suitable grounded cable gland where it enters the industrial steel enclosure.

If this is not possible, chassis ground screw terminals are available on the G123-814.

The length of bare wire should be minimised. Connect the shield at each end of the cable to chassis ground.

This compact brushless Servo Motor is designed to meet the special requirements

of main battle tanks with 2-in-1 stator (double motor) arrangement to accommodate the high power needed.

The brushless servo motor is intended to be integrated into a traverse actuator with a gearbox,

brake and manual input/ auxiliary drive assembly.

Auto-negotiation settings can be accessed via the 914-X Series Unified Diagnostic GUI when connected to the console 914-HDE

diagnostic port. A standard 8P8C (RJ45) modular jack provides the mechanical interface for the Ethernet port. The

port is auto MDI/MDIX capable and supports jumbo frames up to 9000 bytes. Note: sustained back-to-back jumbo

frames are supported up to 4000 bytes, larger frame sizes require increased interframe gaps.

When configured for single expansion mode (default), the 914-EX combines the traffic from both Ethernet ports,

along with diagnostic information, onto a single medium speed expansion channel on the 914-HDE. This bandwidth

is dynamically shared between the two Ethernet ports, allowing for total throughput of up to 1000 Mb/s.

Optionally, the 914-EX can be configured for dual expansion mode, which uses two medium speed expansion

channels on the 914-HDE. This mode allows for a full 1000 Mb/s of bandwidth per Ethernet port and is ideal for

high bandwidth video over IP or GigE vision applications. Since the 914-HDE motherboard multiplexes the Ethernet

data from the 914-EX card and other expansion cards in the system, the total system bandwidth usage must be

considered, and be at (or under) the maximum optical bandwidth available for the system. Refer to Section 3.2 for

detailed information 914-X series card bandwidth usage.

FANUC VMIC VMIVME5010 I/O PRINTED CIRCUIT BOARD PCB  PLC

VMI VME VMIC 4941 332-004941-424 J

VMIC VMEbus PC BOARD VMIVME 7696

VMIC VMIVME 5588 Fiber Optic Reflective Memory Module

Fanuc VMIVME 2200 VME A8 RELY #2 Circuit Board 332-012200-100 C

GE VMIVME-7486 VMIC VME PCB BOARD

VMIVME-9304 CPU BOARD W/ NEC FGA-002A 

FANUC VMIVME-3230 / VMIVME3230

28296 VMIC PCB  VMIVME  MODEL 1150 332-001150-102 N

FANUC VMIC VMI VME-2528 128-BIT TTL DIGITAL I/O INPUT  PLC PCB

GENERAL ELECTRIC VMIC-7700 GE Fanuc vmic-7700 Converteam PIB310

VMIC VMIVME-7697-36 0 Single Board Computer/512MB /P3 850 Mhz

FANUC VMIVME-2210 / VMIVME2210

GE VMIC PCI-5565-010 PLC Module Via FEDEX/DHL

GENERAL ELECTRIC DS3820VMIC1A1B / DS3820VMIC1A1B

VMIC VMIVME-7697-16 7 Single Board Computer