MOOG D136-006-001 EtherCAT slave interface

Installation consists of mounting a horizontal DIN rail to the vertical rear surface of an industrial steel enclosure.

The rail release clips on the G123-814 should face downward to allow front panel and terminal

markings to be clearly readable and to allow cooling airflow to the internal electronics.

An important consideration for module placement is electromagnetic interference (EMI) from other equipment in the enclosure.

For example, VFs and AC servo drives generate high levels of EMI.

be sure to check other equipment for EMC compliance before placing it near the G123-814.

Cooling

Vents at the top and bottom of the G123-814 chassis provide cooling for internal electronic equipment. These vents should be kept clear.

It is important to ensure that the equipment below does not generate hot exhaust gases that could heat the G123-814.

PlacementA horizontal DIN rail, mounted on the vertical rear surface of an industrial steel enclosure,

is the intended method of mounting.

The rail release clip of the G122-829A001 should face down,

so the front panel and terminal identifications are readable and so the internal electronics receive a cooling airflow.

These Application Notes are a guide to applying the G122-829A001 P-I Servoamplifier.

These Application Notes can be used to:

 Determine the closed loop structure for your application.

 Select the G122-829A001 for your application. Refer also to data sheet G122-829.

 Use these Application Notes to determine your system configuration.

  Draw your wiring diagram.

 Install and commission your system.GE Fanuc/ VMIC VMIVME-5532S VMEBus Fiber-Optic Repeater Link