ABB 8VZZ000403H1 HBR01-CJC H-Base Red Cold Junction

The HBR01-CJC the mounting base is for RAI04, Redundant, 16-CH, TC & mV analog input modules. 

The base includes a built-in RTD that can be used for Cold Junction Compensation.

Two (2) 16-point headers on the base provide connections to either (2) pluggable 

16-point terminal blocks for direct connection of field signal wires or to SPK0x_-yy marshaling cables when field signal wires are landed on 3rd party termination hardware.

Features and benefits

Termination for up to sixteen (16) analog I/O process signals within a horizontal row.

All SD I/O modules & bases of all types (Singular or Redundant) AND (Compact or Full-size), are 100% fully compatible with each other. 

Thus, Singular & Redundant, Compact or Full-size I/O modules can be mounted within a single, common HN800 I/O bus.

Optional mechanical keying can be implemented to prevent insertion of the wrong I/O module type.

Latching device on the base locks the base into position on DIN-Rail.

Industry standard 35-mm DIN rail, Horizontal row mounting.

processor load

• Optical communication

• Industrial grade hardware with no moving parts

• Long life cycle, easy upgrading

• Robust reliance file system, insusceptible post power loss

07EA90-SI ABB modules are used to convert analog signals to digital signals and transmit them to the control system for monitoring and controlling industrial processes.

These accuracy settings are only used when negotiating for time mastership with 

other nodes in the underlying Harmony control network.

Message Wait Period

Message wait period is the Period that Harmony Server waits before attempting to 

assume time mastership on the control network. This property is used only when 

Time Synchronization is enabled. The permissible values are between 180 and 3660 

seconds. Additionally, the configured value must greater than the Master Update Period.

Symphony Plus Control & I/O BRC410

ƒ Performance increase depends on specific

function blocks used, but in general

performance of latest module (BRC410)

compared with older modules:

ƒ ~ 10x vs. MFP01/02/11/12

ƒ ~ 4x vs. BRC100/200

ƒ Enhanced On-Line Configuration provided

by BRC410

ƒ BRC410 also provides ModBus TCP

ƒ BRC410 support 30,000 block addresses

and 4,000 Modbus TCP/IP points

ƒ Infi90 Modulebus support*

ƒ Downloadable firmware

I/O SYSTEMS - SD SERIES I/O DO05

The DO05 digital output module provides16, CH-2-CH isolated electromechanical relay contact outputs. 

The electromechanical relay contacts are capable of handling up to 3.0 A. 

The module executes at 1 msec cycle and has an average response time of 0.5 msec based on when command is received from controller. 

The DO05 module provides staple jumpers to select between NO or NC contacts.

FC 221 (I/O Device Definition) sets DO module operating parameters and each output channel is configured

using FC 225 (Digital Output CH) to set indivdual output channel parameters such as alarm state setting, 

default state on loss of communication with controller, etc.

You may need the following additional products：