Prosoft AN-X2-ABRIO-EIPSCN Remote I/O to Ethernet/IP Scanner Module Ethernet Configuration

Cabling and Termination

Follow Allen-Bradley cabling recommendations for remote I/O. Refer to Approved

Vendor List for DH, DH+, DH-485. and Remote I/O Cables, publication ICCG-2.2.

February 1996.

On the AN-X module, the connections should be line 1. shield, line 2.

Ethernet Configuration

The AN-X2-ABRIO-EIPSCN module connects a controller on remote I/O such as a

PLC-5 to scan I/O modules on Ethernet.

Before you can use the AN-X2-ABRIO-EIPSCN, you must configure its network

properties on Ethernet.

Ethernet Configuration

AN-X can be configured:

• to use a static (unchanging) IP address

• to obtain its IP address from a DHCP server

• to use the fixed link-local address 169.254.42.84

AN-X modules are shipped with the link-local address 169.254.42.84.

Unless you have control of the DHCP server, in most applications you will assign the

AN-X a static IP address. Otherwise the DHCP server may assign a different IP address

each time AN-X powers up, and any software that accesses the AN-X module would have

to be reconfigured.

If you are using multiple AN-X modules, connect and configure one at a time, since

initially they will all be set to the same link-local IP address.

IMPORTANT!

If you are connecting AN-X to an existing Ethernet network, consult the

network administrator to obtain information about how you should

configure AN-X or to obtain a static IP address for AN-X.