Beckwith Electric M‑3520 Intertie Protection Relay

Intertie Protection M‑3520 Integrated Protection System®

• Integrated Protection System for DER Intertie, providing:

 Loss of parallel utility operation protections

 Abnormal power flow protections

 Comprehensive suite of phase and ground

fault backed protections

 Abnormal operating protections

 Reconnect and Sync Check functions

• Microprocessor-based Intertie Protection Relay integrates

protection, metering, monitoring and waveform capture

• Provides 18 base protective relay functions and

3 optional protective functions

• Local and remote serial communications capabilities, plus

IRIG-B interface

Standard Functions

• Sync check with Phase, ∆V and ∆F with deadline/deadbus options (25)

• Phase undervoltage (27) protection

• Neutral over/undervoltage (59G/27G) protection

• Sensitive dual-setpoint, reverse power detection (32)

• Sensitive negative-sequence overcurrent protection and alarm (46)

• Negative sequence voltage (47)

• Instantaneous overcurrent (50) protection

• Instantaneous neutral overcurrent (50G) protection

• Three-phase inverse time overcurrent (51V) with voltage control/voltage restraint

• Neutral inverse time overcurrent (51G) protection

• Phase overvoltage (59) protection

• Peak overvoltage (59I) protection

• VT fuse-loss detection and blocking (60FL)

• Directional inverse and definite time phase overcurrent (67)

• Directional inverse and definite time neutral overcurrent (67N)

• Reconnect enable (79)

• Over/Underfrequency (81 O/U)

Optional Functions

• Dual-zone phase distance protection for phase fault backup (21)

• Out of Step (78)

• Rate of change of frequency (81R)

Standard Features

• Eight programmable outputs and six programmable inputs

• Oscillograph recording

• 32-target storage

• Metering of all measured parameters

• Three communications ports (two RS-232. one RS-485)

• Standard 19" rack-mount design

• Removable printed circuit board and power supply

• Both 50 and 60 Hz models available

• Both 1 and 5 Amp rated CT inputs available

• M-3822 IPScom® Communications Software

• IRIG-B time synchronization

Optional Features

• Redundant power supply

• M-3915 Target Module

• M-3931 Human-Machine Interface Module

• M-3801D IPSplot® PLUS Oscillograph Analysis Software

• 4-Wire RS-485 Connection