Beckwith Electric M-2148 Adpapter Panel

The Beckwith Electric M-2148 Adapter Panel, used in conjunction

with the M-2001 series Tapchanger Control, uses modern electronic

digital design and digital processing circuitry to achieve an overall

stability and resolution unattainable with electromechanical and

analog design tapchanger controls. CMOS semiconductors are used

throughout the design. The M-2148 Adapter Panel, with the M-2001

series Tapchanger Control, provides a solid state voltage control relay

designed to directly replace the General Electric LRT 48 control.

There are several sizes of LRT 48 controls, therefore, verify that the

M-2148 is the correct replacement.

The combination of the Tapchanger Control and Adapter Panel includes

the following features:M-2148-P: Replaces General Electric LRT-48

Controls and includes the M-0115A and M-0127A for paralleling.

(M-0329B is not available)M-2148-B: Replaces General Electric

LRT-48 Controls and includes the M-0329B for LTC Backup Control

Protection.

• Voltage waveform sampling and digital processing circuitry ensure

accurate rms voltage sensing in the presence of distortion on the

input voltage and current.

• Control accuracy is +/-0.3 % when tested in accordance with the

ANSI/IEEE C57.15.9-1999 standard over a temperature range of –30° C

to +65° C. The control accuracy is +/-0.5 % when tested over the full

operational temperature range of –40° C to +85° C.

• Input and output circuits are protected against system transients.

Units pass all requirements of ANSI/IEEE C37.90.1- 1989. which defines

surge withstand capability. All input and output terminals will withstand

1500 V ac rms to chassis or instrument ground for one minute with a

leakage current not to exceed 25 mA, for all terminals to ground.

Input and output circuits are electrically isolated from each other, from

other circuits and from ground.