GE Fanuc IC693MDL740 Digital Input/Output Module Series 90-30

DESCRIPTION: The GE Fanuc IC693MDL740 is a Series 90-30 module. The module is a positive logic output module with sixteen (16) source outputs with a capacity of 0.5 amps per channel. The module operates from 12 to 24 volts DC (20%, -15%). It has two (2) sets of outputs with two (3) channels per set.

About IC693MDL740

The IC693MDL740 is a GE Fanuc Series 90-30 programmable logic controller (PLC) module. This module is a positive logic output module that specifically provides current to connected loads from the module common or positive power bus. It has two (2) sets of eight (8) channels, each rated for 0.5 amp loads.

The IC693MDL740 has front panel LED indicators located on the top of the module. These LEDs represent the start-up status of each module channel and the operational status of the module, respectively. As a source-output module, each channel of this module is capable of powering common electrical loads such as contactors, relays, indicator lights, buzzers, horns, and other D24 VDC powered devices. This module does not have an internal fuse, so an external fuse can be installed for further protection of the module.

The IC693MDL740 installs in any available slot on a 5-slot or 10-slot series 90-30 baseboard. The number of module instances varies as long as the controller has enough memory to accommodate this 16-point output module.

The IC693MDL740 is rated at 12/24 volts DC and has an operating voltage range of 12 to 24 volts DC (20%, -15%). The module's output characteristics include a 4.78 amp inrush current of 10 ms, a maximum output voltage drop of 1 VDC, an unsteady-state leakage current of 1 mA, an ON response time of 2 ms, and maximum and Off response times of 2 ms maximum. The module draws 110 mA (all outputs on) from a 5-volt bus on the backplane.

The IC693MDL740 module is a 12 to 24 volt DC rated positive logic output module. There are 16 outputs in two banks of 8 outputs, each with a common power output terminal.The IC693MDL740 module has positive logic characteristics and is used as a current source for loads from the user's common and positive power buses. Output devices are connected between the negative power bus and the module outputs.The IC693MDL740 module is compatible with several load devices, including solenoid valves and motor starters. The output voltage range of the module is 12 to 24 volts DC. The maximum output current is 0.5 amps per module point and the maximum output voltage is 2 amps per common line. The corresponding maximum open and close response time is 2 milliseconds. The rated inrush current for a duration of 10 milliseconds is 4.78 amps.

IC693MDL740 Frequently Asked Questions

What is the rated output current per channel of the IC693MDL740 module?

The module's rated output current is 0.5 amps.

What is the maximum output current per group?

The maximum output current per group is 2 amps.

How many output groups does the IC693MDL740 have?

The IC693MDL740 has two (2) output groups.

IC693MDL740 Technical Description

The GE IC693MDL740 module is a digital input/output module.There are sixteen (16) output points on the IC693MDL740 digital I/O module.