The GE General Electric Speedtronic Mark V gas turbine control system is a version of GE's long line of highly reliable electro-hydraulic control (EHC) systems for steam and gas turbine control.
The Mark V gas turbine control system meets all gas turbine control requirements while providing a high level of reliability through advanced protection and multiple redundancies.
Every product in our inventory is tested and ready to ship. We are proud to offer a large inventory of these critical boards with a standard warranty on every purchase.
The GE Auxiliary Interface Board DS200ADGIH1AAA features a 40-pin connector, 60 jumpers, and a 6-pin connector.
The GE Auxiliary Interface Board DS200ADGIH1AAA is also equipped with multiple test points. The width of the board is 8 inches.
The DS200ADGIH1AAA is 6 inches long and is designed to be mounted in the drive's board cabinet.
It has four screws that align with a location on the board rack for screw mounting.
Test points provide a means of testing the circuitry on the board. However, only qualified service personnel should test the board.
Service personnel must have test equipment calibrated and designed for the task. The controls must be set up correctly and the probes must be designed for use with the tester.
Place the board on a flat surface and place a protective bag underneath the board.
In addition, due to the risk of static electricity, service personnel must wear a wrist strap at all times.
When the wrist strap is properly fitted, one end of the strap is attached to the wrist and the other end is clipped to the metal leg of the workbench or desk.
It can also be attached to other metal structures. Static electricity is attracted to the metal ground and then discharged from the circuit board or your body.
Another appropriate step to reduce static build-up is to avoid moving the board around while holding it in your hands. The friction of walking can cause static buildup.
This is especially true in cool, dry weather conditions. If you do not have a wrist strap, you can also touch the static bag containing the board to a metal structure, such as a chair or metal table leg.
Frequently asked questions about the DS200ADGIH1AAA
What are the dimensions of the DS200ADGIH1AAA?
The DS200ADGIH1AAA is 8 inches wide.The DS200ADGIH1AAA is 6 inches long.
How are the claws marked on the DS200ADGIH1AAA?
The claws on the DS200ADGIH1AAA are marked with EG1-EG4. On the DS200ADGIH1AAA, they are located in a square format on the DS200ADGIH1AAA.
wechat/whatsapp:
+86-181-4410-0983
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved