Product Specifications
The DeltaV Smart Switches is based on hardware produced
by a recognized supplier of industrial-grade networking
equipment. All switches are fan-less and have redundant
power connections. Same models are also available in high
temperature, conformal coated versions for use in harsh
environments. The firmware features are identical in all models
of the DeltaV Smart Switch.
The DeltaV Smart Switches are preconfigured for use exclusively
within the DeltaV control network or the networks listed in
Table 1 above. All switch configuration is performed using
the DeltaV Network Device Command Center [for DeltaV
10.3 configuration is only done through the DeltaV Setup
Wizard using the serial port Command Line Interface]. These
configuration interfaces provide very limited access to switch
configuration parameters. General administrator access to the
DeltaV Smart Switches is disabled to prevent possible mis
configuration of the switch that would impact DeltaV network
performance. A list of the available configuration parameters is
listed in the DeltaV Setup Parameter section
of these specifications.
In DeltaV v13.3 and later the DeltaV Smart Switches can be
installed in the DeltaV 2.5 network or other DeltaV networks
external to the DeltaV control network (see Table 1). For
the DeltaV Smart Switches to be installed in a network, the
switches must be connected to a DeltaV workstation running
control modules. It can be installed in the DeltaV virtualization
networks only if the network is accessible to a DeltaV
workstation (virtual or physical) running control modules.
These specific control modules are required to run the DeltaV
Network Device Command Center application. DeltaV Operator
Workstations are not capable of running these control modules.
wechat/whatsapp:
+86-181-4410-0983
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved