Autronica Fire brigade loop panel BU-110

Features

• User-friendly display and operator controls

• Scroll function for more alarms

• Text display suitable for full darkness operation

• On-wall mounting

• Conforms to EN 54 regulations

• Conforms to CE standards

• Designed to meet the requirement of the major

maritime classification societies

Description / Application

The unit has been designed for use with AutroSafe 4

Interactive Fire Detection System.

From the Fire Brigade Loop Panel BU-110 it is possible to

mute the panel’s internal buzzer, silence/resound

sounders/bells etc. and reset the system.

The panel can be configured (by means of the

configuration tool) to show detection zones and point

information in an alarm situation, or detection zones

only.

Only points in alarm are shown in the display. Faults and

disablements are indicated by LED indicators. The total

number of detection zones in alarm will always be

shown.

By operating the More Events Button, it is possible to

scroll through and view detailed information of the first

64 alarms (or 32 first alarms, if the panel is configured to

show both detection zones and points).

The panel is powered by the detection loop.

Operator controls

The panel offers the following buttons:

• More Events button for scrolling through several

alarms

• Silence Buzzer (60 dB) for silencing the internal buzzer

(access level 1). The internal buzzer will remain muted

until a new alarm is triggered

• Silence Alarm button

• Combined Reset button/Lamp Test (access level 1)

• Contrast settings: to start the contrast settings

(access level 1), press and hold the Silence Buzzer

button for 5 seconds until audible beep, observe

changes, then release the button to confirm the new

contrast (a new audible beep is heard)

Indicators

The panel provides the following indicators:

• Fire symbol, Alarm Routing Activated, Fault, Function

Disabled, Test, System Fault, Power, More Events

• Internal buzzer

Capacity

A maximum of 8 panels can be connected to the

detection loop.

Compatibility - AutroGuard Protectors

When using AutroGuard protectors, note that

BU-110 firmware 1.6 or newer is required.