A-B 1336-CONV-SP14A DC BUS Fuse Replacement Kit

About the 1336-CONV-SP14A

The Allen Bradley 1336-CONV-SP14A DC BUS Fuse Replacement Kit is for use with 1336 Plus,

Force and Impact AC digital drives with a DC fuse and diode replacement kit rated at 200A, a

It is rated at 460 volts AC and has a rated output of 60 horsepower.

The fuse is located on the drive's main chassis, between the drive's power supply board and the main control board mounting plate; the fuse provides circuit protection from line surges.

The 1336-CONV-SP14A fuse kit contains 200A rated Class CC fuses to provide the specified short circuit rating of the drive.

This module is installed on the drive's main chassis using the following installation procedure.

First, disconnect power to the drive and check that the drive's terminal base (TB1) DC and -DC terminals are zero volts.

Connect the 200A fuse from the DC BUS fuse kit to the fuse box bolt and connect the diode (diode supplied with D2) to the fuse box bolt.

Tighten the bolts using a tightening torque of 11.0 to 12.5 N-m to secure the fuses and supplied diodes to the fuse box.

Insert the basic drive board, power supply board, and main control board mounting plates into the drive.

Rotate the drive and check the installation status with the LEDs on the drive.

1336-CONV-SP14A Technical Description

Allen-Bradley AC Drive DC Bus Fuse Replacement, 200 Amp, D Rack Compatible