Woodward easYgen-600 Technical Manual Genset Control Key characteristics

Key characteristics

• With ARM-based 32-bit SCM, highly integrated hardware, high reliability level

• Multilingual interface (English, Chinese, Spanish, Russian, Portuguese, Turkish,

Polish, and French) making commissioning convenient for factory personnel

• Improved LCD wear-resistance and scratch resistance due to hard screen acrylic

• Silicon panel and pushbuttons for better operation in high-temperature environment

• RS485 communication port enabling remote control, remote measuring, remote

communication via ModBus protocol

• Equipped with CAN bus port to communicate with J1939 genset. Monitoring

frequently-used data such as water temperature, oil pressure, speed, fuel

consumption and so on of ECU machine, and additionally also control start, stop,

raising speed, and speed droop via CAN bus port

• Suitable for 3-phase 4-wire, 3-phase 3-wire, single phase 2-wire, and 2-phase 3-wire

systems with voltage 120/240 V and frequency 50/60 Hz

• easYgen-1600 only: Collects and shows 3-phase voltage, current, power

parameter, and frequency of generator and additionally 3-phase mains voltage.

Mains/Generator Line voltage (UAB, UBC, and UCA), Phase voltage (UA, UB, and UC).

• easYgen-600 only: Collects and shows 3-phase voltage, current, power parameter

and frequency of generator. Generator Line voltage (UAB, UBC, and UCA), Phase

voltage (UA, UB, and UC).

• Phase sequence, frequency, Load current IA, IB, IC

• Each phase: Total active power [kW], Total reactive power [kvar], Total apparent

power [kVA], Average power factor PF

• Accumulated Total generator power [kWh], [kvarh], [kVAh]

• easYgen-1600 only: For Mains, controller has over and under voltage, over and

under frequency, loss of phase and phase sequence wrong detection functions

• For generator, controller has over and under voltage, over and under frequency, loss

of phase, phase sequence wrong, over and reverse power, over current functions

• 3 fixed analog sensors: Engine temperature, oil pressure, and fuel level

• Precision measure and display parameters about Engine, Temp. (WT) °C/°F both be

displayed Oil pressure (OP) kPa/psi/bar all be displayed Fuel level (FL) %(unit) Speed

(SPD) r/min (unit) Battery Voltage (VB) V (unit) Charger Voltage (VD) V (unit) Hour

count (HC) can accumulate to max. 65535 hours. Start times can accumulate to

max. 65535 times

• Protection: automatic start/stop of the genset

• easYgen-1600 only: ATS (Auto Transfer Switch) control with perfect failure

indication and protection function

• All output ports are relay-out