Woodward easYgen-600 Technical Manual Genset Control Functions

Functions

• Protection: automatic start/stop of the genset, ATS (Auto Transfer Switch) control

with failure indication and protection function

• All output ports are relay-out

• Parameter settings: parameters can be modified and stored in internal FLASH

memory and cannot be lost even in case of a power outage; most of them can be

adjusted using front panel of the controller and all of them can be modified using

ToolKit-SC on a PC via USB or RS485 ports.

• Temperature, oil pressure and fuel level curves can be used directly and users can

define the sensor curves by themselves.

• Multiple crank disconnect conditions (generator frequency, speed sensor, oil

pressure) are optional.

• Event log, real-time clock, scheduled start & stop generator (can be set as start

genset once a day/week/month with or without load).

• Start-up logo and display time are user-defined.

• Can be used on pumping units and as an indicating instrument (indicate and alarm

are enable only, relay is inhibited).

• Maintenance function: Actions (warning or shutdown) can be set when maintenance

time out.

• Instead of conventional analog modulation with a potentiometer, all parameters use

digital adjustment for more reliability and stability.

• Accumulative total run time and total electric energy of A and B. The user can reset

it to 0 and re-accumulate the value, which allows to count the total value.