Meggitt VibroSmart® VSV301 + VSB300 monitoring module Applications

Applications information

The VSV301 monitoring module is ideal for

monitoring, protecting, analysing and diagnosing

critical assets such as gas turbines, steam turbines,

hydro turbines and other rotating machines. A

VSV301 can be used as a stand-alone module or

as part of a more comprehensive monitoring

system operating with a VibroSight Server (and

data repository).

VibroSmart® systems (VSV30x + VSB300,

VSI010 + VSB010 and VSN010) conform to the

IEC 61850-3 requirements for power plant and

utility applications – when installed in specific

configurations. Contact Meggitt SA and/or refer

to the VibroSmart® distributed monitoring system

(DMS) hardware manual for further information.

For specific applications and other information,

contact your local Meggitt representative.

SPECIFICATIONS

Supported sensors

Currently available :Compatible with a range of sensors and signal conditioners using

2-wire current transmission and 3-wire voltage transmission

Dynamic input channels

Number of independent channels : 2

Measurement range

•Voltage (AC+DC) : ± 3 or ± 30 VPEAK

•Current : 15 or 150 mA

Frequency bandwidth (−0.1 dB) : 0.1 Hz to 19 kHz

•Analog high-pass filter :An optional (software configurable) analog high-pass filter can be

added to the AC path to configure the high-pass cutoff frequency

(−3 dB) as 0.1. 1.0 or 3.0 Hz.

This filter can also be disabled to allow DC-coupling of the input.

Input impedance

•Voltage : ≥ 100 kΩ, between the differential (high and low) inputs

•Current : 202 Ω ± 3 Ω, between the differential (high and low) inputs

Accuracy

•Amplitude : ≤ 1% of input FSD (measurement bandwidth from 10 Hz to 1 kHz)

•Phase : ≤ 1.5 ° (measurement bandwidth from 10 Hz to 1 kHz)

Signal to noise ration (SNR) : ≥ 80 dB (measurement bandwidth from 10 Hz to 2 kHz)

Common-mode voltage (CMV) range : ± 5 V

Common-mode rejection ratio (CMRR) :> 60 dB (at 50 / 60 Hz)

Crosstalk attenuation : Typically 60 dB

Auxiliary input channel – used as a tachometer input

Triggering method :Crossing of threshold on rising edge of signal

Triggering threshold (rising edge) : 2/3 of peak-peak value

Voltage range : ± 30 VRMS / ± 42.4 VAC ( PEAK )  or  60 VDC